When.com Web Search

  1. Ads

    related to: forstner wood boring drill bits 1 5 inch wide electric range stainless steel

Search results

  1. Results From The WOW.Com Content Network
  2. Benjamin Forstner - Wikipedia

    en.wikipedia.org/wiki/Benjamin_Forstner

    In 1886, Forstner patented the Forstner bit. [1] The bit was revolutionary as it did not feature the lead screw (which Forstner called the "gimlet-point") or the cutting lips of more conventional wood boring bits, [clarify] and thus proved especially useful to gunsmiths and high-end woodworkers. The bit was unsurpassed in drilling a smooth ...

  3. Drill bit - Wikipedia

    en.wikipedia.org/wiki/Drill_bit

    Twist drill bits range in diameter from 0.002 to 3.5 in (0.051 to 88.900 mm) [9] and can be as long as 25.5 in (650 mm). [10] The geometry and sharpening of the cutting edges is crucial to the performance of the bit. Small bits that become blunt are often discarded because sharpening them correctly is difficult and they are cheap to replace.

  4. Drill bit sizes - Wikipedia

    en.wikipedia.org/wiki/Drill_bit_sizes

    ANSI B94.11M-1979 sets size standards for jobber-length straight-shank twist drill bits from 1/64 inch through 1 inch in 1/64 inch increments. For Morse taper -shank drill bits, the standard continues in 1/64 inch increments up to 1¾ inch, then 1/32 inch increments up to 2¼ inch, 1/16 inch increments up to 3 inches, 1/8 inch increments up to ...

  5. List of timber framing tools - Wikipedia

    en.wikipedia.org/wiki/List_of_timber_framing_tools

    Chalk line or ink line used to snap lines on the wood. Ink and a slurry of charcoal were used like chalk. Carpenter pencil; Scratch awl or similar tools were used to scratch lines on wood before the pencil was commonly used beginning in the 19th century in the U.S. Try square; Steel square is also known as a framing square. Historically a ...

  6. Boring (manufacturing) - Wikipedia

    en.wikipedia.org/wiki/Boring_(manufacturing)

    A part's-eye view of a boring bar. Hole types: Blind hole (left), through hole (middle), interrupted hole (right). In machining, boring is the process of enlarging a hole that has already been drilled (or cast) by means of a single-point cutting tool (or of a boring head containing several such tools), such as in boring a gun barrel or an engine cylinder.

  7. List of screw drives - Wikipedia

    en.wikipedia.org/wiki/List_of_screw_drives

    Pentalobe screw sizes include TS1 (also known as P2 or 0.8 mm, used on the iPhone 4 and subsequent models), TS4 (also known as P5 or 1.2 mm, used on the MacBook Air [since late 2010], the MacBook Pro with Retina Display and the 2015 MacBook) and TS5 (also known as P6 or 1.5 mm, used on the 2009 MacBook Pro battery).