Search results
Results From The WOW.Com Content Network
However, the function of traffic shaping is more likely done by a Cable Modem or policy traffic switch. A CMTS may also act as a bridge or router. A customer's cable modem cannot communicate directly with other modems on the line. In general, cable modem traffic is routed to other cable modems or to the Internet through a series of CMTSs and ...
It can allow a direct connection from a home LAN to a WWAN, if a wireless router or access point is present on the WAN as well and tethering is allowed. Many modems now incorporate the features mentioned below and thus are appropriately described as residential gateways, such as some Internet providers which offer a cable modem router combo. [8]
"Cable router" has two basic meanings: Single Cable Router (SCR) - a down-conversion device for the radio data link. It converts RF signal from a satellite dish or TV antenna to the user-defined IF channel. Usually, many SCRs are connected to a single coaxial cable - each converting to a separate IF channel. The entire system referred to as ...
A Network Termination Device (NTD), network termination (NT), [1] or NTE (for network termination equipment) is a customer-side network interface device used by the Australian National Broadband Network (NBN). Network termination devices provide multiple bridges for customers to access the NBN. There are different types of NTDs for the various ...
A terminating resistor for a television coaxial cable is often in the form of a cap, threaded to screw onto an F connector. Antenna cables are sometimes used for internet connections; however, RG-6 should not be used for 10BASE2 (which should use RG-58) as the impedance mismatch can cause phasing problems with the baseband signal.
Examples of CPE types include modems, routers, gateways, set-top boxes, and VoIP-phones. TR-069 was first published in May 2004, with amendments in 2006, 2007, 2010, July 2011 (version 1.3), [ 1 ] and November 2013 (version 1.4 am5) [ 2 ] The Home Gateway Initiative (HGI), Digital Video Broadcasting Project (DVB) and WiMAX Forum have endorsed CWMP.
The term cable modem refers to this cable-specific PHY. The Network Layer is implemented as an IP host in that it has its own IP address used by the network operator to maintain the device. In the transport layer the cable modem supports UDP in association with its own IP address, and it supports filtering based on TCP and UDP port numbers to ...
A LAG is a method of inverse multiplexing over multiple Ethernet links, thereby increasing bandwidth and providing redundancy. It is defined by the IEEE 802.1AX-2008 standard, which states, "Link Aggregation allows one or more links to be aggregated together to form a Link Aggregation Group, such that a MAC client can treat the Link Aggregation Group as if it were a single link."