Ads
related to: lath plaster anchors for wood ceiling blocks
Search results
Results From The WOW.Com Content Network
Lath seen from the back with white plaster coat oozing through. Lath and plaster is a building process used to finish mainly interior dividing walls and ceilings. It consists of narrow strips of wood which are nailed horizontally across the wall studs or ceiling joists and then coated in plaster.
Roof laths span across between the rafters and support the wood shingles. A lath or slat is a thin, narrow strip of straight-grained wood used under roof shingles or tiles, on lath and plaster walls and ceilings to hold plaster, and in lattice and trellis work. [1] Lath has expanded to mean any type of backing material for plaster.
Figure 1 of the original patent for the molly bolt, U.S. Patent No. 2,018,251. The molly bolt was patented in 1934 by George Frederick Croessant. [3] Although his patent acknowledges that expandable fasteners of this general kind were already known, Croessant's patent is intended to provide "an improved and adequate anchoring grip that may be retightened if necessary and that will permit ...
Lime plaster was a common building material for wall surfaces in a process known as lath and plaster, whereby a series of wooden strips on a studwork frame was covered with a semi-dry plaster that hardened into a surface. The plaster used in most lath and plaster construction was mainly lime plaster, with a cure time of about a month. To ...
This lath and plaster technique became widely used. In exterior wall applications, the lath is installed over a weather-resistant asphalt-impregnated felt or paper sheet that protects the framing from the moisture that can pass through the porous stucco. Following World War II, the introduction of metal wire mesh, or netting, replaced the use ...
The staff bead, a 1-inch dowel with approx 1 ⁄ 3 shaved off the back, is set on the external corner by the joiner on site, fastened to wooden plugs set into the brick/block seams, or to the wood frame. Plaster is run up to the staff bead and then cut back locally to the bead or "quirked" to avoid a weak feather edge where the plaster meets ...
Wall plugs. A wall plug (UK English) also known as an anchor (US) or "Rawlplug" (UK), is a fibre or plastic (originally wood) insert used to enable the attachment of a screw in a material that is porous or brittle, or that would otherwise not support the weight of the object attached with the screw.
Wattle and daub is a composite building method used for making walls and buildings, in which a woven lattice of wooden strips called "wattle" is "daubed" with a sticky material usually made of some combination of wet soil, clay, sand, and straw. Wattle and daub has been used for at least 6,000 years and is still an important construction method ...