Ads
related to: do you need a subwoofer for turntable speakers to run
Search results
Results From The WOW.Com Content Network
A speaker that can handle 200 watts thermally at 200 Hz, may sometimes be damaged by only a few watts at some very low frequency, like 10 Hz. Power handling specifications are usually generated destructively, by long-term industry standard noise signals (IEC 268, for example) that filter out low frequencies and test only the thermal capability ...
The MTX Jackhammer, a 22-inch subwoofer made by MTX Audio, is capable of 2.5 inches of linear cone excursion, one way. That is a total range of 5 inches, which is potentially hazardous. The Thunder 1000000, the record holder for the largest subwoofer ever made, with a diameter of 60 inches, is capable of 6 inches of peak to peak cone excursion.
All speaker drivers have a means of electrically inducing back-and-forth motion. Typically there is a tightly wound coil of insulated wire (known as a voice coil) attached to the neck of the driver's cone. In a ribbon speaker, the voice coil may be printed or bonded onto a sheet of very thin paper, aluminum, fiberglass or plastic.
A 7.1.2-channel system has seven main speakers, one subwoofer and two rear speakers. As a general rule, more speakers equals bigger, broader sound. Size: Does size matter?
Phono input is a set of input jacks, usually mini jacks or RCA connectors, located on the rear panel of a preamp, mixer or amplifier, especially on early radio sets, to which a phonograph or turntable is attached. [1] Modern phono cartridges give a very low level output signal of the order of a few millivolts which the circuitry amplifies and ...
The measure of the low frequency (many tens of Hz) noise contributed by the turntable of an analogue playback system. It is caused by imperfect bearings, uneven motor windings, vibrations in driving bands in some turntables, room vibrations (e.g., from traffic) that is transmitted by the turntable mounting and so to the phono cartridge.