Ads
related to: do you need a subwoofer for turntable speakers to hear
Search results
Results From The WOW.Com Content Network
In most installations, you'll need to adjust your TV speaker settings so the audio gets directed to just the soundbar. Some TVs will do that automatically when such speakers are detected ...
Front-loaded subwoofers have one or more subwoofer speakers in a cabinet, typically with a grille to protect the speakers. In practice, many front-loaded subwoofer cabinets have a vent or port in the speaker cabinet, thus creating a bass reflex enclosure. Even though a bass reflex port or vent creates some additional phase delay, it adds SPL ...
The standard surround setup consists of three front speakers LCR (left, center and right), two surround speakers LS and RS (left and right surround respectively) and a subwoofer for the low-frequency effects (LFE) channel, that is low-pass filtered at 120 Hz.
However, whereas a 5.1 surround sound system combines both surround and rear channel effects into two channels (commonly configured in home theatre set-ups as two rear surround speakers), a 7.1 surround system splits the surround and rear channel information into four distinct channels, in which sound effects are directed to left and right ...
A small pub or nightclub may have a single monitor speaker on stage so that the lead vocalist can hear their singing and the signal for the monitor may be produced on the same mixing console and audio engineer as the front-of-house mix. A stadium rock concert may use a large number of monitor wedges and a separate mixing console and engineer on ...
All speaker drivers have a means of electrically inducing back-and-forth motion. Typically there is a tightly wound coil of insulated wire (known as a voice coil) attached to the neck of the driver's cone. In a ribbon speaker, the voice coil may be printed or bonded onto a sheet of very thin paper, aluminum, fiberglass or plastic.