When.com Web Search

Search results

  1. Results From The WOW.Com Content Network
  2. Turbojet - Wikipedia

    en.wikipedia.org/wiki/Turbojet

    The turbojet is an airbreathing jet engine which is typically used in aircraft. It consists of a gas turbine with a propelling nozzle . The gas turbine has an air inlet which includes inlet guide vanes, a compressor, a combustion chamber, and a turbine (that drives the compressor).

  3. HFB 320 Hansa Jet - Wikipedia

    en.wikipedia.org/wiki/HFB_320_Hansa_Jet

    As certified, the Hansa Jet can carry up to 12 passengers. Its General Electric CJ610 turbojet engines enabled the aircraft to achieve a maximum speed of 900 km/h (486 kn) along with a maximum endurance in excess of 2,200 km (1,200 nmi). [6] The decision to mount these engines far aft contributed to the relatively quiet cabin. [2]

  4. Pratt & Whitney J57 - Wikipedia

    en.wikipedia.org/wiki/Pratt_&_Whitney_J57

    The prestigious Collier Trophy for 1952 was awarded to Leonard S. Hobbs, chief engineer of United Aircraft Corporation, for "designing and producing the P&W J57 turbojet engine". The engine was produced from 1951 to 1965 with a total of 21,170 built. Many J57 models shipped since 1954 contained 7-15% of titanium, by dry weight.

  5. General Electric J47 - Wikipedia

    en.wikipedia.org/wiki/General_Electric_J47

    The J47 design used experience from the TG-180/J35 engine which was described by Flight magazine in 1948 [4] as the most widely used American-conceived turbojet.. The turbojet featured a revolutionary anti-icing system where hollow frame struts allowed heated airflow to pass through from the compressor, allowing fighter jets equipped with the engine to function at high altitudes, and in cold ...

  6. Pratt & Whitney J75 - Wikipedia

    en.wikipedia.org/wiki/Pratt_&_Whitney_J75

    The Pratt & Whitney J75 (civilian designation: JT4A) is an axial-flow turbojet engine first flown in 1955. A two-spool design in the 17,000 lbf (76 kN) thrust class, the J75 was essentially the bigger brother of the Pratt & Whitney J57 (JT3C).

  7. Pratt & Whitney JT3D - Wikipedia

    en.wikipedia.org/wiki/Pratt_&_Whitney_JT3D

    The Pratt & Whitney JT3D is an early turbofan aircraft engine derived from the Pratt & Whitney JT3C turbojet. It was first run in 1958 and was first flown in 1959 under a B-45 Tornado test aircraft. Over 8,000 JT3Ds were produced between 1959 and 1985.

  8. Pratt & Whitney J58 - Wikipedia

    en.wikipedia.org/wiki/Pratt_&_Whitney_J58

    The Pratt & Whitney J58 (company designation JT11D-20) is an American jet engine that powered the Lockheed A-12, and subsequently the YF-12 and the SR-71 aircraft. It was an afterburning turbojet engine with a unique compressor bleed to the afterburner that gave increased thrust at high speeds. Because of the wide speed range of the aircraft ...

  9. General Electric J85 - Wikipedia

    en.wikipedia.org/wiki/General_Electric_J85

    The General Electric J85 is a small single-shaft turbojet engine. Military versions produce up to 3,500 lb f (16 kN) of thrust dry; afterburning variants can reach up to 5,000 lb f (22 kN). The engine, depending upon additional equipment and specific model, weighs from 300 to 500 pounds (140 to 230 kg).