Search results
Results From The WOW.Com Content Network
The term scrub radius derives from the fact that either in the positive or negative mode, the tire does not turn on its centerline (it scrubs the road in a turn) and due to the increased friction, more effort is needed to turn the wheel. Large positive values of scrub radius, 4 inches/100 mm or so, were used in cars for many years.
Figure 1 Hard wheel rolling on and deforming a soft surface, resulting in the reaction force R from the surface having a component that opposes the motion. (W is some vertical load on the axle, F is some towing force applied to the axle, r is the wheel radius, and both friction with the ground and friction at the axle are assumed to be negligible and so are not shown.
The S and SL models include a 20x9-inch back wheel fitted with a 255mm width tire, and 18x7.5-inch front wheels with 225mm wide tires. The SLR and R models have the same front wheels and tires, but feature an upgraded 20x11-inch rear wheel fitted with a 305mm wide tire. All models have a front double wishbone suspension with an anti-roll bar.
If the tire is not checked, it has the potential to cause vibration in the suspension of the vehicle on which it is mounted. In tire retail shops, tire/wheel assemblies are checked on a spin-balancer, which determines the amount and angle of unbalance. Balance weights are then fitted to the outer and inner flanges of the wheel. [2]
Victory Motorcycles was an American motorcycle brand based in Spirit Lake, Iowa, United States.It began selling its vehicles in 1998, and began winding down operations in January 2017 to be succeeded by the revived traditional American motorcycle brand Indian, which are both (since 2011) owned by parent company Polaris Industries.
All the driving wheels have an out-of-balance which is caused by their off-centre crank pins and attached components. The main driving wheels have the greatest unbalance since they have the biggest crankpin as well as the revolving portion of the main rod. They also have the valve gear eccentric crank and the back end of the eccentric rod.
Power oversteer is the process of applying power through the throttle pedal while turning to break the traction forces on the driving wheels. Doing this causes the vehicle to slide, and is also known as a powerslide, and the vehicles movement is primarily based on the non-driving wheels (usually the steering wheels).
The greatest effort is required from a locomotive when starting. At this time, if the engineer applies too much power to the wheels (i.e., for a steam locomotive, the engineer opens the regulator too far) the turning force applied to the wheel will greatly exceed the opposing friction force affected by the surface of the rail, and the wheel will turn without being able to move the train forward.