Ad
related to: stuck at fault testing equipment
Search results
Results From The WOW.Com Content Network
A stuck-at fault is a particular fault model used by fault simulators and automatic test pattern generation (ATPG) tools to mimic a manufacturing defect within an integrated circuit. Individual signals and pins are assumed to be stuck at Logical '1', '0' and 'X'. For example, an input is tied to a logical 1 state during test generation to ...
ATPG (acronym for both automatic test pattern generation and automatic test pattern generator) is an electronic design automation method or technology used to find an input (or test) sequence that, when applied to a digital circuit, enables automatic test equipment to distinguish between the correct circuit behavior and the faulty circuit behavior caused by defects.
Basic fault models in digital circuits include: Static faults, which give incorrect values at any speed and sensitized by performing only one operation: the stuck-at fault model. A signal, or gate output, is stuck at a 0 or 1 value, independent of the inputs to the circuit. the bridging fault model. Two signals are connected together when they ...
In digital electronics, fault coverage refers to stuck-at fault coverage. [1] It is measured by sticking each pin of the hardware model at logic '0' and logic '1', respectively, and running the test vectors. If at least one of the outputs differs from what is to be expected, the fault is said to be detected.
Various fault types may be applied to the diagnostic model. Commonly used fault types are: stuck-at faults, which simulates a node stuck high or low; stuck-open fault, which simulates a disconnected node; bridging faults, which simulate an unwanted connected between two nodes; transition-delay faults, which simulate slow signal switching on a node
Chevron (CVX) aims to temporarily pause the Gorgon Train Three plant during the second quarter of 2021.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
While the task of testing a single logic gate at a time sounds simple, there is an obstacle to overcome. For today's highly complex designs, most gates are deeply embedded whereas the test equipment is only connected to the primary Input/outputs (I/Os) and/or some physical test points. The embedded gates, hence, must be manipulated through ...