Ad
related to: unifi configuration diagram instructionsget.usermanualsonline.com has been visited by 10K+ users in the past month
Search results
Results From The WOW.Com Content Network
Initial configuration of the service as part of zero-touch or one-touch configuration process; Service re-establishment (ex. after device is factory-reset, exchanged) Remote subscriber support Verification of the device status and functionality; Manual reconfiguration; Firmware and configuration management Firmware upgrade/downgrade
Configuration change control is a set of processes and approval stages required to change a configuration item's attributes and to re-baseline them. Configuration status accounting is the ability to record and report on the configuration baselines associated with each configuration item at any moment of time.
In addition, when the scope of a diagram crosses the common LAN/MAN/WAN boundaries, representative hypothetical devices may be depicted instead of showing all actually existing nodes. For example, if a network appliance is intended to be connected through the Internet to many end-user mobile devices, only a single such device may be depicted ...
Ubiquiti Inc. (formerly Ubiquiti Networks, Inc.) [3] is an American technology company founded in San Jose, California, in 2003. [1] [4] Now based in New York City, [5] Ubiquiti manufactures and sells wireless data communication and wired products for enterprises and homes under multiple brand names.
Note that in the diagram the incorrect label ESSID (Extended Service Set Identifier) refers to the service set identifier. In IEEE 802.11 wireless local area networking standards (including Wi‑Fi ), a service set is a group of wireless network devices which share a service set identifier ( SSID )—typically the natural language label that ...
Static routing may have the following uses: When using static address configuration (in the absence of DHCP or Router Advertisements) it can be used to provide a default route, forming a special case of the longest prefix match as it has a prefix length of zero and therefore always matches, and always matches last.
A LAG is a method of inverse multiplexing over multiple Ethernet links, thereby increasing bandwidth and providing redundancy. It is defined by the IEEE 802.1AX-2008 standard, which states, "Link Aggregation allows one or more links to be aggregated together to form a Link Aggregation Group, such that a MAC client can treat the Link Aggregation Group as if it were a single link."
The standard provides configuration management and device management, allowing for configurations and firmware to be pushed to access points (APs). Because the overall state design of the CAPWAP protocol is largely the same as the finite-state machine (FSM) in LWAPP, a detailed diagram is not needed. [citation needed]