Search results
Results From The WOW.Com Content Network
The important socket dimensions which the standard does specify are: A minimum insertion of 9.6 mm from the face of the socket-outlet to the first point of contact with a live part, [67] a minimum distance of 9.5 mm from the line and neutral apertures to the periphery of the socket face, [68] and not to exceed dimensions for the apertures of 7. ...
The US military uses a variety of phone connectors including 9 ⁄ 32-inch (0.281-inch, 7.14 mm) and 1 ⁄ 4-inch (0.25 inch, 6.35 mm) diameter plugs. [43] Commercial and general aviation (GA) civil aircraft headsets often use a pair of phone connectors. A standard 1 ⁄ 4-inch (6.3
These "extend" the length of the socket and allow access to nuts or bolts that are difficult to reach. Extensions are typically 1 ⁄ 2 to 20 inches (15 to 510 mm) in length in roughly 1-to-3-inch (25 to 75 mm) increments. They are sometimes attached together to get a needed length extension, and often have a knurled section for added grip.
The addition is a 3 ⁄ 16-inch (4.8 mm) diameter round or U-shaped ground pin, 1 ⁄ 8 in (3.2 mm) longer than the power blades (so the device is grounded before the power is connected) and located from them by 1 ⁄ 4 in (6.4 mm) edge-to-edge or 15 ⁄ 32 in (11.9 mm) center-to-center.
The flat pins for the 10 A version measure 6.25 by 1.55 mm (0.246 by 0.061 in) and 8.0 by 1.9 mm (0.315 by 0.075 in) for the 20 A version, and are set at 30° to the vertical at a nominal pitch of 7.92 mm (0.312 in). The pin length is the same as in the Chinese version. The earthing pin length is 21.4 mm (0.843 in) for the 10 A version and 21.8 ...
Color-coded PS/2 connection ports (purple for keyboards and green for mice) on the rear of a personal computer An S-video connector: because this is a female connector, Pin 1 is at lower right. Mini-DIN connectors are 9.5 millimetres (3 ⁄ 8 in) in diameter and come in seven patterns, with the number of pins from three to nine. Each pattern is ...
Novar B9E base, 9 pins with 1.02 mm diameter in a 17.45 mm pin circle diameter arc, one of several Compactron types, which looks similar to Magnoval (but a Novar tube in a Magnoval socket will not make good pin contact, and a Magnoval tube in a Novar socket may damage the socket). Sub-Magnal B11A base (American), 11-pins. Also used as ...
Two spanners, both nominal size 5 ⁄ 8 in, with a diagram superimposed to show the logic that allows them both to be nominal size 5 ⁄ 8 in when their actual sizes are clearly different (across-flats distance vs screw diameter). The across-flats definition is the common standard today, and has been for many decades.