Ad
related to: how to adjust qa1 coil over shocks rean 85 s10 parts
Search results
Results From The WOW.Com Content Network
The package included a total lowered ride height of approximately 2" over stock (1.5" from suspension, ~0.5" from shorter tire diameter), thicker front sway bar (33mm), rear sway bar (23mm), quicker ratio (12:1) steering box, upgraded Decarbon or Bilstein gas shock absorbers, ZQ8 specific bump stops and a frame brace. Some ZQ8 models were also ...
The twist-beam rear suspension (also torsion-beam axle, deformable torsion beam, or compound crank) is a type of automobile suspension based on a large H- or C-shaped member. The front of the H attaches to the body via rubber bushings , and the rear of the H carries each stub-axle assembly, on each side of the car.
Height adjustable suspension is a feature of certain automobile suspension systems that allow the motorist to vary the ride height or ground clearance. This can be done for various reasons including giving better ground clearance over rough terrain, a lower ground clearance to improve performance and fuel economy at high speed, [1] or for stylistic reasons.
Camber and caster: Some coilover suspension kits may also be supplied with adjustable top mounts. Depending on the design of the car's suspension these top mounts can allow the adjustment of camber and/or caster. Some coilovers use the car's original top mounts and are therefore not adjustable.
In automobiles, a double wishbone suspension is an independent suspension design using two (occasionally parallel) wishbone-shaped arms to locate the wheel. Each wishbone or arm has two mounting points to the chassis and one joint at the knuckle. The shock absorber and coil spring mount to the wishbones to control vertical movement.
A short long arms suspension (SLA) is also known as an unequal-length double wishbone suspension. The upper arm is typically an A-arm and is shorter than the lower link, which is an A-arm or an L-arm, or sometimes a pair of tension/compression arms. In the latter case, the suspension can be called a multi-link, or dual-ball joint suspension.
The hydraulic shock absorbers used on the rear suspensions of motorcycles are essentially the same as those used in other vehicle applications. Motorcycle shocks do differ slightly in that they nearly always use a coil-over spring. In other words, the spring for the rear suspension is a coil spring that is installed over, or around, the shock.
A strut is a structural component that combines the shock absorber with other suspension parts like the coil spring and steering knuckle into one compact unit [15] Unlike a shock absorber, a strut has a reinforced body and stem.