Ad
related to: how to adjust qa1 coil over shocks rean 85s10 for sale
Search results
Results From The WOW.Com Content Network
The twist-beam rear suspension (also torsion-beam axle, deformable torsion beam, or compound crank) is a type of automobile suspension based on a large H- or C-shaped member. The front of the H attaches to the body via rubber bushings , and the rear of the H carries each stub-axle assembly, on each side of the car.
A Shock Response Spectrum (SRS) [1] is a graphical representation of a shock, or any other transient acceleration input, in terms of how a Single Degree Of Freedom (SDOF) system (like a mass on a spring) would respond to that input. The horizontal axis shows the natural frequency of a hypothetical SDOF, and the vertical axis shows the peak ...
Height adjustable suspension is a feature of certain automobile suspension systems that allow the motorist to vary the ride height or ground clearance. This can be done for various reasons including giving better ground clearance over rough terrain, a lower ground clearance to improve performance and fuel economy at high speed, [1] or for stylistic reasons.
Camber and caster: Some coilover suspension kits may also be supplied with adjustable top mounts. Depending on the design of the car's suspension these top mounts can allow the adjustment of camber and/or caster. Some coilovers use the car's original top mounts and are therefore not adjustable.
A short long arms suspension (SLA) is also known as an unequal-length double wishbone suspension. The upper arm is typically an A-arm and is shorter than the lower link, which is an A-arm or an L-arm, or sometimes a pair of tension/compression arms. In the latter case, the suspension can be called a multi-link, or dual-ball joint suspension.
In automobiles, a double wishbone suspension is an independent suspension design using two (occasionally parallel) wishbone-shaped arms to locate the wheel. Each wishbone or arm has two mounting points to the chassis and one joint at the knuckle. The shock absorber and coil spring mount to the wishbones to control vertical movement.
A shock absorber or damper is a mechanical or hydraulic device designed to absorb and damp shock impulses. It does this by converting the kinetic energy of the shock into another form of energy (typically heat) which is then dissipated. Most shock absorbers are a form of dashpot (a damper which resists motion via viscous friction).
The package included a total lowered ride height of approximately 2" over stock (1.5" from suspension, ~0.5" from shorter tire diameter), thicker front sway bar (33mm), rear sway bar (23mm), quicker ratio (12:1) steering box, upgraded Decarbon or Bilstein gas shock absorbers, ZQ8 specific bump stops and a frame brace. Some ZQ8 models were also ...