Search results
Results From The WOW.Com Content Network
Compressor characteristic is a mathematical curve that shows the behaviour of a fluid going through a dynamic compressor. It shows changes in fluid pressure , temperature , entropy , flow rate etc.) with the compressor operating at different speeds.
In refrigerators, defrosting (or thawing) is the removal of frost and ice. A defrosting procedure is generally performed periodically on refrigerators and freezers to maintain their operating efficiency. Over time, as the door is opened and closed, letting in new air, water vapour from the air condenses on the cooling elements within the cabinet.
Actual cubic feet per minute (ACFM) is a unit of volumetric flow. It is commonly used by manufacturers of blowers and compressors. [1] This is the actual gas delivery with reference to inlet conditions, whereas cubic foot per minute (CFM) is an unqualified term and should only be used in general and never accepted as a specific definition without explanation.
A defrost timer taken out of a household refrigerator. The defrost mechanism in a refrigerator heats the cooling element (evaporator coil) for a short period of time and melts the frost that has formed on it. [1] The resulting water drains through a duct at the back of the unit. Defrosting is controlled by an electric or electronic timer.
Thermodynamic heat pump cycles or refrigeration cycles are the conceptual and mathematical models for heat pump, air conditioning and refrigeration systems. [1] A heat pump is a mechanical system that transmits heat from one location (the "source") at a certain temperature to another location (the "sink" or "heat sink") at a higher temperature. [2]
Cubic feet per minute (CFM) is an often confusing term because it has no single definition that applies to all instances. Gases are compressible, which means that a figure in cubic feet per minute cannot necessarily be compared with another figure when it comes the mass of the gas.
Cooling capacity is the measure of a cooling system's ability to remove heat. [1] It is equivalent to the heat supplied to the evaporator/boiler part of the refrigeration cycle and may be called the "rate of refrigeration" or "refrigeration capacity".
Fig.5 Schematic diagram of a GM-cooler. V l and V h are buffer volumes of the compressor. The compression heat is removed by the cooling water of the compressor via a heat exchanger. The rotary valves alternatingly connect the cooler to the high- and the low-pressure sides of the compressor and runs synchronous with the displacer.