Search results
Results From The WOW.Com Content Network
In refrigerators, defrosting (or thawing) is the removal of frost and ice. A defrosting procedure is generally performed periodically on refrigerators and freezers to maintain their operating efficiency. Over time, as the door is opened and closed, letting in new air, water vapour from the air condenses on the cooling elements within the cabinet.
It is equivalent to the heat supplied to the evaporator/boiler part of the refrigeration cycle and may be called the "rate of refrigeration" or "refrigeration capacity". As the target temperature of the refrigerator approaches ambient temperature, without exceeding it, the refrigeration capacity increases thus increasing the refrigerator's COP.
A representative pressure–volume diagram for a refrigeration cycle. Vapour-compression refrigeration or vapor-compression refrigeration system (VCRS), [1] in which the refrigerant undergoes phase changes, is one of the many refrigeration cycles and is the most widely used method for air conditioning of buildings and automobiles.
Actual cubic feet per minute (ACFM) is a unit of volumetric flow. It is commonly used by manufacturers of blowers and compressors. [1] This is the actual gas delivery with reference to inlet conditions, whereas cubic foot per minute (CFM) is an unqualified term and should only be used in general and never accepted as a specific definition without explanation.
Peltier coolers are often used where a traditional vapor-compression cycle refrigerator would be impractical or take up too much space, and in cooled image sensors as an easy, compact and lightweight, if inefficient, way to achieve very low temperatures, using two or more stage peltier coolers arranged in a cascade refrigeration configuration ...
When a Carnot cycle runs in reverse, it is called a reverse Carnot cycle. A refrigerator or heat pump that acts according to the reversed Carnot cycle is called a Carnot refrigerator or Carnot heat pump, respectively. In the first stage of this cycle, the refrigerant absorbs heat isothermally from a low-temperature source, T L, in the amount Q L.
Surging takes place when compressor is operated off the design point and it affects the whole machine and this is aerodynamically and mechanically undesirable. It can damage the rotor bearings, rotor seals, compressor driver and affect the whole cycle operation. It results in high temperature, high vibration and leads to flow reversal. [4] [11 ...
Cubic feet per minute (CFM) is an often confusing term because it has no single definition that applies to all instances. Gases are compressible, which means that a figure in cubic feet per minute cannot necessarily be compared with another figure when it comes the mass of the gas.