Search results
Results From The WOW.Com Content Network
Arc welding power supplies can deliver either direct (DC) or alternating (AC) current to the work, while consumable or non-consumable electrodes are used. The welding area is usually protected by some type of shielding gas (e.g. an inert gas), vapor, or slag. Arc welding processes may be manual, semi-automatic, or fully automated.
The electrical energy for the percussion welding can be supplied by a transformer, as alternating current (or rectified), or by the discharge of capacitors.Because of the short duration of the arc and of the fact that all of the weld energy comes from this arc, the electrical resistance of the parts to be welded does not affect the amount of heat generated at the weld and substances of ...
The International Institute of Welding Technology IIW published the Guideline "Recommendations for the HFMI Treatment" [3] in October 2016. An overview of higher frequency hammers (HFMI) is presented, and recommendations for the correct application of the method and quantitative measurements for quality assurance the guideline provides the basis for measurements of HFMI improved welded joints ...
AN/ARC-133: Ultra high frequency (UHF) Radio communication system, pressurized version of AN/ARC-34: AN/ARC-164: Ultra high frequency (UHF) radio communication system: AN/ARC-182: Very High Frequency (VHF)/Ultra high frequency (UHF) two-way, multi-mode radio communication system: Rockwell Collins: AN/ARC-186: Very High Frequency (VHF) AM/FM ...
Maintaining a short arc length, while preventing contact between the tungsten electrode and the workpiece, is also important. [13] To strike the welding arc, a high-frequency generator (similar to a Tesla coil) provides an electric spark. This spark is a conductive path for the welding current through the shielding gas and allows the arc to be ...
It offered a high deposition rate, but the high cost of inert gases limited its use to non-ferrous materials and prevented cost savings. In 1953, the use of carbon dioxide as a welding atmosphere was developed, and it quickly gained popularity in GMAW, since it made welding steel more economical. In 1958 and 1959, the short-arc variation of ...
The ARC-190 is a military HF radio that operates between 2-30 MHz and transmits at 300+ watts.It features a dual heterodyne receiver/transmitter that uses IF frequencies of 97.8 and 1.8 MHz, an antenna coupler that is pressurized to 7±1 PSI with dry nitrogen (air) which (1) prevents high voltage arcing, (2) prevents corrosion, (3) provides a uniform cooling medium, and one of various controls ...
A line impedance stabilization network (LISN) [1] is a device used in conducted and radiated radio-frequency emission and susceptibility tests, as specified in various electromagnetic compatibility (EMC)/EMI test standards (e.g., by CISPR, International Electrotechnical Commission, CENELEC, U.S. Federal Communications Commission, MIL-STD, DO-160 Sections 20-21-22).