When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   Square head cap screws up to and including 3 ⁄ 4 inch (19.05 mm) have a head 1 ⁄ 8 inch (3.175 mm) larger than the shank; screws larger than 3 ⁄ 4 inch (19.05 mm) have a head 1 ⁄ 4 inch (6.35 mm) larger than the shank. [9] In 1919, Dyke defined them as screws that are threaded all the way to the head. [10] socket screw

3. 32 mm cabinetmaking system - Wikipedia

   en.wikipedia.org/wiki/32_mm_cabinetmaking_system

   A typical 5 mm shelf stud may measure 15-16 mm long, and has a thin flange of about 7 mm diameter halfway at its length. Distance of the front row of holes to the front edge: 37 mm The system includes matching fittings, with which furniture sides can be secured to floors, walls, and adjacent cabinets.

4. Door handle - Wikipedia

   en.wikipedia.org/wiki/Door_handle

   This is an accepted version of this page This is the latest accepted revision, reviewed on 5 February 2025. Device to open or close door Various examples of door handles throughout history A door handle or doorknob is a handle used to open or close a door. Door handles can be found on all types of doors including: exterior doors of residential and commercial buildings, internal doors, cupboard ...

5. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   The 85% and 90% rules works best in the range of 1 ⁄ 4 –1 in (6.4–25.4 mm), the sizes most important on many shop floors. Some sizes outside that range have different ratios. Below, these guidelines are explored with examples.

6. Tap and die - Wikipedia

   en.wikipedia.org/wiki/Tap_and_die

   where is the tap drill size, is the major diameter of the tap (e.g., 3 ⁄ 8 in for a 3 ⁄ 8-16 tap), and / is the thread pitch (1 ⁄ 16 inch in the case of a 3 ⁄ 8-16 tap). For a 3 ⁄ 8 -16 tap, the above formula would produce 5 ⁄ 16 , which is the correct tap drill diameter.

7. Hole punch - Wikipedia

   en.wikipedia.org/wiki/Hole_punch

   The holes are positioned symmetrically, with the centers 4 + 1 ⁄ 4 inches (108 mm) apart. It requires paper formats that are at least 9 + 1 ⁄ 2 inches (241 mm) high. There is a variant for half-letter size pages (8 + 1 ⁄ 2 by 5 + 1 ⁄ 2 inches or 220 mm × 140 mm), whose three holes are 2 + 3 ⁄ 4 inches (70 mm) apart.