Search results
Results From The WOW.Com Content Network
A lightbulb socket, lightbulb holder, light socket, lamp socket or lamp holder is a device which mechanically supports and provides electrical connections for a compatible electric lamp base. [1] Sockets allow lamps to be safely and conveniently replaced (re-lamping).
A twilight switch is an electronic component that allows the automatic activation of a lighting circuit when natural light drops in a given environment. Among a large number of uses, the most common is to enable automatic lighting of streets, roads, highways, roads, gardens, courtyards, etc., when sunlight drops below a certain level (e.g.: a ...
The bulb's "turn on" voltage V b is higher than its "turn off" voltage V e. This property, called hysteresis , allows the bulb to function as an oscillator. Hysteresis is due to the bulb's negative resistance , the fall in voltage with increasing current after breakdown, [ 7 ] [ 14 ] which is a property of all gas-discharge lamps .
Moving the light off of a dimmer switch may help, but the best thing to do is replace the old incandescent bulb with an energy-saving LED. Trust us, you can find one that replicates its soft ...
The suffix after the G indicates the pin spread; the G dates to the use of Glass for the original bulbs. GU usually also indicates that the lamp provides a mechanism for physical support by the luminaire: in some cases, each pin has a short section of larger diameter at the end (sometimes described as a "peg" rather than a "pin" [2]); the socket allows the bulb to lock into place by twisting ...
Compact fluorescent mogul-base bulbs are also available, as are adaptors to allow medium-base bulbs to be used in mogul sockets. There are usually two three-way switches near the top of the floor lamp to operate the bulbs. One controls the three-way center bulb, and the other turns on one, two, or all three (or four) of the peripheral bulbs.
A toggle light switch Internal components of a toggle switch. The toggle mechanism provides "snap-action" through the use of an "over-center" geometry. The design was patented in 1916 by William J. Newton and Morris Goldberg. [2] The switch actuator does not control the contacts directly, but through an intermediate arrangement of springs and ...
A 3-way lamp, also known as a tri-light, is a lamp that uses a 3-way light bulb to produce three levels of light in a low-medium-high configuration. A 3-way lamp requires a 3-way bulb and socket, and a 3-way switch. In 3-way incandescent light bulbs, each of the filaments operates at full voltage. Lamp bulbs with dual carbon filaments were ...