Search results
Results From The WOW.Com Content Network
In mechanical engineering, the thread angle of a screw is the included angle between the thread flanks, measured in a plane containing the thread axis. [1] This is a defining factor for the shape of a screw thread .
Lead angle is 90° to the helix angle between the helical tooth face and an equivalent spur tooth face. For the same lead, the lead angle is larger for smaller gear diameters. It is understood to be measured at the standard pitch diameter unless otherwise specified. A spur gear tooth has a lead angle of 90°, and a helix angle of 0°. See ...
The efficiency can be plotted versus the helix angle for a constant friction, as shown in the adjacent diagram. The maximum efficiency is a helix angle between 40 and 45 degrees, however a reasonable efficiency is achieved above 15°. Due to difficulties in forming the thread, helix angle greater than 30° are rarely used.
Omron was established by Kazuma Tateisi (立石一真) in 1933 (as the Tateisi Electric Manufacturing Company) and incorporated in 1948. The company originated in an area of Kyoto called "Omuro (御室) ", from which the name "Omron" was derived. Prior to 1990, the corporation was known as Omron Tateisi Electronics. During the 1980s and early ...
It is one of the most widely used types, and is particularly common on the shank of taper-shank twist drills and machine reamers, in the spindles of industrial drill presses, and in the tailstocks of lathes. The taper angle of the Morse taper varies somewhat with size but is typically 1.49 degrees (around 3 degrees included).
Circa-1960 Saab two-stroke engine 2010 Suzuki K10B engine. Among the first cars to use a straight-three engine is the 1953–1955 DKW F91, powered by a 900 cc (55 cu in) two-stroke engine, although this was predated by the 3 cylinder 15hp Rolls Royce produced in 1905 and a number of other cars of this era also used 3 cylinder engines.
A degree (in full, a degree of arc, arc degree, or arcdegree), usually denoted by ° (the degree symbol), is a measurement of a plane angle in which one full rotation is 360 degrees. [4] It is not an SI unit—the SI unit of angular measure is the radian—but it is mentioned in the SI brochure as an accepted unit. [5]
A range table was a list of angles of elevation a particular artillery gun barrel needed to be set to, to strike a target at a particular distance with a projectile of a particular weight using a propellant cartridge of a particular weight.