Search results
Results From The WOW.Com Content Network
A binary trigger (or pull and release trigger) is a type of device that allows a semi-automatic firearm to fire at an increased rate. A binary trigger works by firing one shot upon pulling the trigger and then firing a subsequent shot upon release of the trigger. Binary triggers are installed through modification of the fire-control group.
Firearms use triggers to initiate the firing of a cartridge seated within the gun barrel chamber.This is accomplished by actuating a striking device through a combination of mainspring (which stores elastic energy), a trap mechanism that can hold the spring under tension, an intermediate mechanism to transmit the kinetic energy from the spring releasing, and a firing pin to eventually strike ...
This allows for an increased rate of fire. However, the shooter must still manually pull the trigger each time it resets for any subsequent shot to be fired. An image of a forced reset trigger from ATF’s Ammunition Technology Division: Technical Bulletin 22-01. Forced reset triggers are installed through replacement of the trigger control group.
The July 14 shooting in Fargo, which killed one officer and wounded two others and a civilian, has put a spotlight on the device and other trigger modifications that are a growing concern for The ...
A variation is the trigger disconnect which prevents the gun from firing until the gun has not only been fully and completely cycled, but the trigger is released and squeezed again. This defines the behavior of semi-automatic firearms which require a separate trigger pull to fire each successive cartridge and ready the next, and this is the ...
A Glock switch functions by applying force to a semi-automatic pistol's trigger bar to prevent it from limiting fire to one round of ammunition per trigger pull. [5] [6] Normally, in a semiautomatic pistol, after firing, the trigger bar catches the firing pin until the trigger is released, but when depressed by the switch it does not catch.
A hell-fire trigger is a device that allows a semi-automatic firearm to fire at an increased rate. The hell-fire clamps to the trigger guard behind the trigger and presses a "finger" against the back of the trigger to increase the force that returns the trigger to its forward position, effectively decreasing the time required for the trigger to reset, allowing for a faster follow-up shot.
This makes the "trigger crank" avoid classification as a machine gun for purposes of gun law in the United States, as stated in an IRS revenue ruling [1] and various other private-letter rulings by ATF. [2] [3] However, a battery-powered "trigger crank" (and by extension Gatling gun) is a machine gun as was determined by the ATF in 2004. [4]