Search results
Results From The WOW.Com Content Network
A toothed belt, timing belt, cogged belt, cog belt, or synchronous belt is a flexible belt with teeth moulded onto its inner surface. Toothed belts are usually designed to run over matching toothed pulleys or sprockets. Toothed belts are used in a wide array of mechanical devices where high power transmission is desired.
Toothed belts were invented in the early 1940s, for use in textile mills. [17] The first known automobile engine to use a timing belt was the American 1954 Devin-Panhard racing car, used an engine converted from pushrods to overhead camshafts through the use of a toothed belt made by the Gilmer Company.
Injection pump for a 12-cylinder diesel engine. An injection pump is the device that pumps fuel into the cylinders of a diesel engine.Traditionally, the injection pump was driven indirectly from the crankshaft by gears, chains or a toothed belt (often the timing belt) that also drives the camshaft.
The clutch brake not only slows or stops the idle gear axis but can also prevent shifting into gear until the clutch pedal is released a few centimetres (or inches) off the floor. In order to shift into gear, the clutch must be halfway off the floor, otherwise, the clutch brake will prevent the transmission from being shifted into or out of gear.
1) the disc component of a disc brake. 2) another name for a detangler - a device that allows the handlebars and fork to revolve indefinitely without tangling the rear brake cable. Safety levers: extension levers, and interrupt brake levers. Used to apply brakes in order for the bicycle to slow down or suddenly stop
A later design of cross-drive transmission, the Allison X1100, was used in the 1970s experimental US MBT-70 and XM1 [3] tanks, then later adopted in the M1 Abrams.This adopts a different principle for the steering cross-coupling: instead of a hydro-dynamic torque converter, it uses a hydrostatic combination of a hydraulic pump and a hydraulic motor.
By 1899 there was widespread adoption in UK bicycle manufacture of the freewheel, usually combined with the back-pedal brake, and conversions were offered to existing bicycles. [8] [9] In 1899 the same system in the USA was known as the “coaster brake”, which let riders brake by pedaling backwards and included the freewheel mechanism. [10]
The most common type is a two-channel sensor that scans a toothed wheel on the motor shaft or gearbox which may be dedicated to this purpose or may be already present in the drive system. Modern Hall effect sensors of this type make use of the principle of magnetic field modulation and are suitable for ferromagnetic target wheels with a module ...