When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Nominal Pipe Size - Wikipedia

   en.wikipedia.org/wiki/Nominal_Pipe_Size

   Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...

3. Drill pipe - Wikipedia

   en.wikipedia.org/wiki/Drill_pipe

   Drill pipe, is hollow, thin-walled, steel or aluminium alloy piping that is used on drilling rigs. It is hollow to allow drilling fluid to be pumped down the hole through the bit and back up the annulus. It comes in a variety of sizes, strengths, and wall thicknesses, but is typically 27 to 32 feet in length (Range 2).

4. List of thread standards - Wikipedia

   en.wikipedia.org/wiki/List_of_thread_standards

   Pipe Threads, General Purpose (Inch) Pipe Thread Form ANSI B1.20.3-1976 (R2013) Dryseal Pipe Threads (Inch) Pipe Thread Form ASME B1.20.7-1991 (R2013) Hose Coupling Screw Threads - Inch: Pipe Thread Form ASME B1.21M-1997 (R2013) Metric Screw Threads - MJ Profile: V Thread Form BS 84: Tables of BS Whitworth, BS Fine and BS Pipe Threads: V Thread ...

5. Pipe (fluid conveyance) - Wikipedia

   en.wikipedia.org/wiki/Pipe_(fluid_conveyance)

   For pipe sizes of NPS 14 inch (DN 350) and greater the NPS size is the actual diameter in inches and the DN size is equal to NPS times 25 (not 25.4) rounded to a convenient multiple of 50. For example, NPS 14 has an OD of 14 inches or 355.60 millimetres, and is equivalent to DN 350.

6. AN thread - Wikipedia

   en.wikipedia.org/wiki/AN_thread

   AN sizes range from -2 (dash two) to -32 in irregular steps, with each step equating to the OD (outside diameter) of the tubing in 1 ⁄ 16-inch increments. Therefore, a -8 AN size would be equal to 1 ⁄ 2-inch OD tube. However, this system does not specify the ID (inside diameter) of the tubing because the tube wall can vary in thickness.

7. Japanese Industrial Standards - Wikipedia

   en.wikipedia.org/wiki/Japanese_Industrial_Standards

   JIS H 4080 – Aluminum and aluminum alloys extruded tubes and cold-drawn tubes; JIS H 4090 – Aluminum and aluminum alloy welded pipes and tubes; JIS H 4100 – Aluminum and aluminum alloy extruded shape; JIS H 4160 – Aluminum and aluminum alloy foils; JIS H 4170 – High purity aluminum foils; JIS H 4301 – Lead and lead alloy sheets and ...