Ad
related to: back illuminated sensor vs front mirror heater with light led bulbs
Search results
Results From The WOW.Com Content Network
A traditional, front-illuminated digital camera is constructed in a fashion similar to the human eye, with a lens at the front and photodetectors at the back. This traditional orientation of the sensor places the active matrix of the digital camera image sensor—a matrix of individual picture elements—on its front surface and simplifies manufacturing.
Exmor R is a back-illuminated version of Sony's CMOS image sensor. [5] Exmor R was announced by Sony on 11 June 2008 and was the world's first mass-produced implementation of the back-illuminated sensor technology. [6] [non-primary source needed] Sony claims that Exmor R is approximately twice as sensitive as a normal front illuminated sensor.
LED power dissipation is modeled as a current source; thermal resistance is modeled as a resistor; and the ambient temperature is modeled as a voltage source. High power light-emitting diodes (LEDs) can use 350 milliwatts or more in a single LED. Most of the electricity in an LED becomes heat rather than light – about 70% heat and 30% light. [1]
The mirror makes the display opaque so it cannot be illuminated from the back. Most often a light source is placed around the perimeter of the LCD. Frontlights are relatively uncommon. Electroluminescent lights present a reflective surface when turned off. This allows for a backlit display which can also be used with ambient light.
Round bulbs, often tinted red to reduce visible light, provide infrared radiant heat suitable for warming of people or animals, but the power density available is low. The development of quartz halogen linear lamps allowed much higher power density up to 200 watts/inch of lamp (8 w/mm), useful for industrial heating, drying and processing ...
A 230-volt LED filament lamp, with an E27 base. The filaments are visible as the eight yellow vertical lines. An assortment of LED lamps commercially available in 2010: floodlight fixtures (left), reading light (center), household lamps (center right and bottom), and low-power accent light (right) applications An 80W Chips on board (COB) LED module from an industrial light luminaire, thermally ...
Infrared heaters can be operated in vacuum or atmosphere. One classification of infrared heaters is by the wavelength bands of infrared emission. Short wave or near infrared for the range from 750 nm to 1.4 μm; these emitters are also named "bright" because still some visible light is emitted; Medium infrared for the range between 1.4 μm and ...
The major advantage of a lighting control system over stand-alone lighting controls or conventional manual switching is the ability to control individual lights or groups of lights from a single user interface device. This ability to control multiple light sources from a user device allows complex lighting scenes to be created.