Search results
Results From The WOW.Com Content Network
2.8 L turbo V6 in a 2006 Saab 9-3. This engine is also known as a A28NET, Z28NET, Z28NEL or B284. The LP9 is a 2.8L turbocharged version used for the Saab 9-3, Saab 9-5, and other GM vehicles. It has the same bore and stroke as the naturally aspirated LP1, however the compression ratio is reduced to 9.5:1. The engine is manufactured at Holden's ...
Production of the 2.8 and 3.1 L (2,837 and 3,135 cc) engines ended in 1994. Production ended for all longitudinal 60° V6s in 1996. GM's performance-parts division continued production of a related crate engine after 1999. 2.8 Applications: 1986–1993 Chevrolet S-10/GMC S-15 Sonoma; 1986–1993 Chevrolet S-10 Blazer/GMC S-15 Jimmy
The High Value engine family from General Motors is a group of cam-in-block or overhead valve V6 engines.These engines feature cast iron blocks and aluminum heads, and use the same 60° vee bank as the 60° V6 family they are based on, but the new 99 mm (3.90 in) bore required offsetting the bores by 1.5 mm (0.059 in) away from the engine center line.
The Chevrolet 90° V6 family of V6 engines began in 1978 with the Chevrolet 200 cu in (3.3 L) as the base engine for the all new 1978 Chevrolet Malibu.The original engine family was phased out in early 2014, with its final use as the 4.3 L (262 cu in) V6 engine used in Chevrolet and GMC trucks and vans.
Atlas is a name for a family of modern inline piston engines for trucks from General Motors, used in the GMT355 and GMT360 platforms. The series debuted in 2002 with the Oldsmobile Bravada, and is also used in the Buick Rainier, the Chevrolet TrailBlazer and Colorado, the GMC Envoy and Canyon, the Hummer H3, Isuzu Ascender and i-370, and the Saab 9-7X.
The 2.2l S10/Sonoma had the starter located in the same position as front wheel drive cars. A rear wheel drive bellhousing is displayed at right, and the integrated front wheel drive bellhousing is displayed at the lower right (in this case, as a part of the GM 6T70 Transmission). GM 60-Degree 2.8/3.1/3.4/3.5/3.9 L V6 (also used by AMC) Buick ...
A big-block engine, variants were produced in 305-, 351-, 401-, and 478-cubic-inch (5.0, 5.8, 6.6, and 7.8 liters respectively) displacements, with considerable parts commonality. During the latter years of production, 379-and-432-cubic-inch (6.2 and 7.1 L) versions with enlarged crankshaft journals were manufactured as well.
Since there is no room in the V between the cylinder banks for an intake system, all the intakes are on one side of the engine, and all the exhausts are on the other side. It uses a firing order of 1-5-3-6-2-4 (which is the firing order used by most straight-six engines), rather than the common V6 firing order of 1-2-3-4-5-6 or 1-6-5-4-3-2.