Search results
Results From The WOW.Com Content Network
It has a 10.3:1 compression ratio. Its fuel economy is 4–6 km/L (11–17 mpg ‑imp; 9.4–14.1 mpg ‑US) in city, and 7–9 km/L (20–25 mpg ‑imp; 16–21 mpg ‑US) on highway. [citation needed]. Holden also produced the 3.2L engines that were used by Alfa Romeo as the basis of its JTS V6 engine. Applications:
The Chevrolet 90° V6 family of V6 engines began in 1978 with the Chevrolet 200 cu in (3.3 L) as the base engine for the all new 1978 Chevrolet Malibu.The original engine family was phased out in early 2014, with its final use as the 4.3 L (262 cu in) V6 engine used in Chevrolet and GMC trucks and vans.
The High Value engine family from General Motors is a group of cam-in-block or overhead valve V6 engines.These engines feature cast iron blocks and aluminum heads, and use the same 60° vee bank as the 60° V6 family they are based on, but the new 99 mm (3.90 in) bore required offsetting the bores by 1.5 mm (0.059 in) away from the engine center line.
Straight-six engines typically use a firing order of 1-5-3-6-2-4. However, a firing order of 1-2-4-6-5-3 is common on medium-speed marine engines. V6 engines with an angle of 90 degrees between the cylinder banks have used a firing orders of R1-L2-R2-L3-L1-R3 or R1-L3-R3-L2-R2-L1. Several V6 engines with an angle of 60 degrees have used a ...
Since there is no room in the V between the cylinder banks for an intake system, all the intakes are on one side of the engine, and all the exhausts are on the other side. It uses a firing order of 1-5-3-6-2-4 (which is the firing order used by most straight-six engines), rather than the common V6 firing order of 1-2-3-4-5-6 or 1-6-5-4-3-2.
GM Vortec 4300 90° V6; GM Iron Duke RWD inline 4 (early RWD Variants, later versions may use a FWD pattern, and have two possible starter locations) Jeep with GM Iron Duke inline 4 2.5L/151 in 3 (1980-1983). These use a Chrysler custom Torqueflite 904 automatic transmission with an integral Chevrolet bellhousing.
3.4L 60° DOHC V6 (LQ1) The LQ1 (also called the Twin Dual Cam or TDC) was a 3.4 L (3,350 cc) DOHC V6 engine ("X-code") based on the aluminum-headed second generation of GM's 60° engine line, sharing a similar block with its pushrod cousins, the 3.1 L LH0 V6 and the then recently retired 2.8 L (2,837 cc) LB6 V6.
The 432.3-cubic-inch (7.1 L) 432 had a 4.875 in × 3.86 in (123.8 mm × 98.0 mm) bore and stroke. [14] In 1973 and 1974, it produced 190 hp (142 kW) net at 3200 RPM and 331 lb⋅ft (449 N⋅m) net torque at 1600 RPM in 1973. [14] There was also a version with enlarged crankshaft journals. The 432 was a 401 with a 478 crankshaft.