Search results
Results From The WOW.Com Content Network
The ECU was much cheaper to produce due to more modern components, and was more standardised than the L-Jetronic ECUs. As per L-Jetronic, a vane-type airflow sensor is used. [4] Compared with L-Jetronic, the fuel injectors used by LE-Jetronic have a higher impedance. [5] Three variants of LE-Jetronic exist: LE1, the initial version.
The design of the 13CU also deviated from the original L-Jetronic design in that it used a hot-wire air mass sensor rather than the Jetronic's mechanical flap sensor. The 13CU was further developed into the 14CU, which had (among other changes) an ECU that was more physically compact. The 14CU was used in US-market Range Rovers in 1989. Both ...
Mid 1980s JECS LH-Jetronic ECU. 40 pin IC bottom left is Hitachi Motorola 6800 clone, 28 pin IC (socketed) immediately right is 16kB ROM containing maps. JECS logo bottom left. Bosch first produced the Jetronic EFI system in 1967. K-Jetronic & L-Jetronic followed from around 1973 [6] which is when Nissan became involved.
The first Bosch engine management system was the Motronic 1.0, which was introduced in the 1979 BMW 7 Series (E23) [8] This system was based on the existing Bosch Jetronic fuel injection system, to which control of the ignition system was added. [9]
Bosch monopoint. Motronic is the trade name given to a range of digital engine control units developed by Robert Bosch GmbH (commonly known as Bosch) which combined control of fuel injection and ignition in a single unit. By controlling both major systems in a single unit, many aspects of the engine's characteristics (such as power, fuel ...
Bosch developed their D-Jetronic (D for Druckfühlergesteuert, German for "pressure-sensor-controlled"), from the Electrojector, which was first used on the VW 1600TL/E in 1967. This was a speed/density system, using engine speed and intake manifold air density to calculate "air mass" flow rate and thus fuel requirements.
The British made engines were run on two SU carburettors, initially HS6 then HIF6 and HIF44 variants (14 years), then two CD175 Stromberg carburettors (2–3 years), Bosch L-Jetronic (7–8 years, aka Lucas 4CU Flapper), then Hitachi Hotwire (5 years, aka Lucas 14CUX), then the GEMS system (many years) and finally Bosch Motronics for 2 years.
Bosch built this system under licence, and marketed it from 1967 as the D-Jetronic. [21] In 1973, Bosch introduced their first self-developed multi-point injection systems, the electronic L-Jetronic, and the mechanical, unpowered K-Jetronic. [23] Their fully digital Motronic system was introduced in 1979. It found widespread use in German ...