Ads
related to: starter motor problems when hot rod is going back
Search results
Results From The WOW.Com Content Network
The engine and all of the ancillary components – starter, generator/alternator, radiator, distributor, carburetor and all others – must be inspected and corrected to factory specifications. The engine itself, plus the transmission, clutch, overdrive unit, and even the driveshaft must be meticulously inspected, cleaned, and measured for wear.
The Chevrolet engine debuted in 2002 with part number 88958604 and sold for about $5000 in 2012. [28] The 604 engine is equipped with aluminum heads, forged steel crankshaft, and an aluminum intake. [28] It produces about 400 horsepower and 400 foot-pounds of torque with a 9.6:1 compression. [28]
Hot Rod 1941 Willys. Critical four-cylinder engine failures, lack of replacement and repair parts and the sheer lack of assistance from Willys turned many Americars into perfect targets for the nascent hot rod community - the Go Devil engine was replaced with many other alternatives, some weaker, some much stronger than the original ...
An automobile starter motor (larger cylinder). The smaller object on top is a starter solenoid which controls power to the starter motor and engages the Bendix drive.. A starter (also self-starter, cranking motor, or starter motor) is a device used to rotate (crank) an internal-combustion engine so as to initiate the engine's operation under its own power.
Popular Hot Rodding was a monthly American automotive magazine from the Motor Trend Group, dedicated to high-performance automobiles, hot rods, and muscle cars.Though it focused primarily on vehicles produced from 1955 to the present day it maintained an emphasis on cars produced from the early 1960s through the mid 1970s.
Altered is a former National Hot Rod Association (NHRA) drag racing class and a current drag racing chassis configuration that forms the basis of many classes of NHRA Competition Eliminator. The altered is "[s]ometimes called the poor man's [d]ragster". [ 1 ]
The engine was a turbocharged 2.3-liter Quad 4 built mainly with factory parts that produced 250 hp (190 kW) at 6400 rpm. [11] The Oldsmobile Aerotech II and Aerotech III were both released in 1989. The Aerotech II is a wagon-back sports coupe concept with a 2.3-liter Quad 4 making 230 hp (170 kW) with some form of forced induction.
Problems with heat-distortion of the early alloy cylinder barrel/head units led to a subsequent redesign that included cooling fins angled at 45° to eliminate cutouts needed for access to the bolts holding the barrels to the crankcase, and the reintroduction of push-rod tubes. The engine was "modular" in that the individual cylinder/head units ...