Ads
related to: can intake manifold leak coolant
Search results
Results From The WOW.Com Content Network
A leak in the head gasket - often called a "blown head gasket" - can result in a leak of coolant, the combustion gasses, or both. Blue smoke from the exhaust suggests that excess oil is entering the combustion chambers (although there are other possible causes than a head gasket leak).
The coolant used in many liquid-cooled engines must be renewed periodically and can freeze at ordinary temperatures thus causing permanent engine damage when it expands. Air-cooled engines do not require coolant service, and do not suffer damage from freezing, two commonly cited advantages for air-cooled engines.
The intake manifold vacuum, with wide open throttle, is lower in these conditions, which causes the PCV valve to open and the crankcase gases flow to the intake system. [13] The greater flow rate of intake air during these conditions means that a greater quantity of blow-by gases can be added to the intake system without compromising the ...
However, if the part is also machined, the internal porosity will be exposed and the part will leak if pressurized. Machined die castings that need to hold fluids (intake manifolds, coolant connectors, transmission cases, pump housings and fluid power components) are routinely sealed for life using acrylic resins.
This led to elimination of coolant flowing through a 'dry' intake manifold, a potential source of leaks and minimized unnecessary heat transfer. To perform this change, the front of the engine block was extended to include provisions for the coolant to flow through a crossover in the block.
The most notable contaminant is lead, so vehicles equipped with catalytic converters can run only on unleaded fuel. Other common catalyst poisons include sulfur, manganese (originating primarily from the gasoline additive MMT), and silicon, which can enter the exhaust stream if the engine has a leak that allows coolant into the combustion chamber.
However, the tripartite mixture resulting from employing both EGR and PCV in an engine (i.e. exhaust gas, fresh air, and oil vapour) can cause the buildup of sticky tar in the intake manifold and valves. This mixture can also cause problems with components such as swirl flaps, where fitted. (These problems, which effectively take the form of an ...
Litigation has linked it with intake manifold gasket failures in General Motors' (GM's) 3.1L and 3.4L engines, and with other failures in 3.8L and 4.3L engines. One of the anti-corrosion components presented as sodium or potassium 2-ethylhexanoate and ethylhexanoic acid is incompatible with nylon 6,6 and silicone rubber , and is a known ...
Ad
related to: can intake manifold leak coolant