Ads
related to: internal spur gear generator motor assembly system with compressor
Search results
Results From The WOW.Com Content Network
Klimov TV3-117 turboshaft engine. The accessory drive is the large casting on the top. The accessory drive is a gearbox that forms part of a gas turbine engine. [1] Although not part of the engine's core, it drives the accessories – such as generators, pumps for fuel and lubrication oil, air compressors, hydraulic pumps and engine starters – that are otherwise essential for the operation ...
Free-piston engine used as a gas generator to drive a turbine. A free-piston engine is a linear, 'crankless' internal combustion engine, in which the piston motion is not controlled by a crankshaft but determined by the interaction of forces from the combustion chamber gases, a rebound device (e.g., a piston in a closed cylinder) and a load device (e.g. a gas compressor or a linear alternator).
Drum Motor with Planetary Gear Drum Motor With Helical Spur Gear. The drum motor concept was first recorded in 1928, but it was not used until the early 1950s, when it was first produced specifically for conveyor belt applications. The goal was to produce a compact, totally enclosed single component drive unit with high efficiency and lower ...
Spur gears or straight-cut gears are the simplest type of gear. They consist of a cylinder or disk with teeth projecting radially. They consist of a cylinder or disk with teeth projecting radially. Viewing the gear at 90 degrees from the shaft length (side on) the tooth faces are straight and aligned parallel to the axis of rotation .
The linear generator also allows the control of the resistance force, and therefore a better control of the piston's movement and of the reaction. The total efficiency (including mechanical and generator) of free-piston linear generators can be significantly higher than conventional internal combustion engines and comparable to fuel cells.
Profile of a spur gear Notation and numbering for an external gear Notation and numbering for an internal gear. The tooth surface (flank) forms the side of a gear tooth. [1] It is convenient to choose one face of the gear as the reference face and to mark it with the letter “I”. The other non-reference face might be termed face “II”.