Search results
Results From The WOW.Com Content Network
Friis's formula is used to calculate the total noise factor of a cascade of stages, each with its own noise factor and power gain (assuming that the impedances are matched at each stage). The total noise factor can then be used to calculate the total noise figure. The total noise factor is given as
Noise figure (NF) and noise factor (F) are figures of merit that indicate degradation of the signal-to-noise ratio (SNR) that is caused by components in a signal chain.These figures of merit are used to evaluate the performance of an amplifier or a radio receiver, with lower values indicating better performance.
The noise factor (a linear term) is more often expressed as the noise figure (in decibels) using the conversion: = The noise figure can also be seen as the decrease in signal-to-noise ratio (SNR) caused by passing a signal through a system if the original signal had a noise temperature of 290 K. This is a common way of expressing the noise ...
Different types of noise are generated by different devices and different processes. Thermal noise is unavoidable at non-zero temperature (see fluctuation-dissipation theorem), while other types depend mostly on device type (such as shot noise, [1] [3] which needs a steep potential barrier) or manufacturing quality and semiconductor defects, such as conductance fluctuations, including 1/f noise.
To determine the noise figure of an amplifier one uses a noise diode at the input to the amplifier and determines the output noise Y with the diode switched on and off. Knowing both Y and the ENR, one can then determine the amount of noise contributed by the amplifier and hence can calculate the noise figure of the amplifier.
In telecommunications, effective input noise temperature is the source noise temperature in a two-port network or amplifier that will result in the same output noise power, when connected to a noise-free network or amplifier, as that of the actual network or amplifier connected to a noise-free source.
Friis' original idea behind his transmission formula was to dispense with the usage of directivity or gain when describing antenna performance. In their place is the descriptor of antenna capture area as one of two important parts of the transmission formula that characterizes the behavior of a free-space radio circuit.
ITU-R 468 (originally defined in CCIR recommendation 468-4, therefore formerly also known as CCIR weighting; sometimes referred to as CCIR-1k) is a standard relating to noise measurement, widely used when measuring noise in audio systems. The standard, [1] now referred to as ITU-R BS.468-4, defines a weighting filter curve, together with a ...