Ads
related to: hall effect sensor instructions- Design support
Eval Boards & Kits.
Simulation & Modelling.
- Selection Guide
Ready-to-use sensor solutions
View products
- Training
Watch latest training videos
Find out more!
- Learn and Collaborate
Infineon Developer Community
Join the discussion!
- Design support
Search results
Results From The WOW.Com Content Network
Hall effect devices produce a very low signal level and thus require amplification. The vacuum tube amplifier technology available in the first half of the 20th century was too large, expensive, and power-consuming for everyday Hall effect sensor applications, which were limited to laboratory instruments.
The term ordinary Hall effect can be used to distinguish the effect described in the introduction from a related effect which occurs across a void or hole in a semiconductor or metal plate when current is injected via contacts that lie on the boundary or edge of the void. The charge then flows outside the void, within the metal or semiconductor ...
The planar Hall sensor is a type of magnetic sensor based on the planar Hall effect of ferromagnetic materials. [1] [2] It measures the change in anisotropic magnetoresistance caused by an external magnetic field in the Hall geometry. As opposed to an ordinary Hall sensor, which measures field components perpendicular to the sensor plane, the ...
A hall effect sensor uses the Hall effect to measure the magnitude of a magnetic field. Deutsch: Entstehung eines vertikalen Hall-Sensors . Ein Hall-Sensor verwendet den Hall-Effekt zur Messung von Magnetfeldern.
The design of the saturable inductor current sensor is similar to that of a closed-loop Hall-effect current sensor; the only difference is that this method uses the saturable inductor instead of the Hall-effect sensor in the air gap. Saturable inductor current sensor is based on the detection of an inductance change. The saturable inductor is ...
The van der Pauw Method is a technique commonly used to measure the resistivity and the Hall coefficient of a sample. Its strength lies in its ability to accurately measure the properties of a sample of any arbitrary shape, as long as the sample is approximately two-dimensional (i.e. it is much thinner than it is wide), solid (no holes), and the electrodes are placed on its perimeter.
A variation of magnetic sensing is the "Hall effect" sensor which utilizes the magnetic sensing of a mechanical gauge's indications. In a typical application, a magnetism-sensitive "Hall effect sensor" is affixed to a mechanical tank gauge that has a magnetized indicator needle, so as to detect the indicating position of the gauge's needle.
The fractional quantum Hall effect is more complicated and still considered an open research problem. [2] Its existence relies fundamentally on electron–electron interactions. In 1988, it was proposed that there was a quantum Hall effect without Landau levels. [3] This quantum Hall effect is referred to as the quantum anomalous Hall (QAH) effect.