Search results
Results From The WOW.Com Content Network
The simplest switched-capacitor (SC) circuit is made of one capacitor and two switches S 1 and S 2 which alternatively connect the capacitor to either in or out at a switching frequency of . Recall that Ohm's law can express the relationship between voltage, current, and resistance as:
An electronic symbol is a pictogram used to represent various electrical and electronic devices or functions, such as wires, batteries, resistors, and transistors, in a schematic diagram of an electrical or electronic circuit. These symbols are largely standardized internationally today, but may vary from country to country, or engineering ...
Figure 2.Greinacher circuit. The Greinacher voltage doubler is a significant improvement over the Villard circuit for a small cost in additional components. The ripple is much reduced, nominally zero under open-circuit load conditions, but when current is being drawn depends on the resistance of the load and the value of the capacitors used.
For DC circuits, a capacitor is analogous to a hydraulic accumulator, storing the energy until pressure is released. Similarly, they can be used to smooth the flow of electricity in rectified DC circuits in the same way an accumulator damps surges from a hydraulic pump. Charged capacitors and stretched diaphragms both store potential energy.
Symbolic circuit analysis is a formal technique of circuit analysis to calculate the behaviour or characteristic of an electric/electronic circuit with the independent variables (time or frequency), the dependent variables (voltages and currents), and (some or all of) the circuit elements represented by symbols. [1] [2]
At low frequencies parasitic capacitance can usually be ignored, but in high frequency circuits it can be a major problem. In amplifier circuits with extended frequency response, parasitic capacitance between the output and the input can act as a feedback path, causing the circuit to oscillate at high frequency.
It is the time required to charge the capacitor, through the resistor, from an initial charge voltage of zero to approximately 63.2% of the value of an applied DC voltage, or to discharge the capacitor through the same resistor to approximately 36.8% of its initial charge voltage.
A voltage divider referenced to ground is created by connecting two electrical impedances in series, as shown in Figure 1. The input voltage is applied across the series impedances Z 1 and Z 2 and the output is the voltage across Z 2. Z 1 and Z 2 may be composed of any combination of elements such as resistors, inductors and capacitors.