Search results
Results From The WOW.Com Content Network
DMS-59 (Dual Monitor Solution, 59 pins) is generally used for computer video cards. It provides two Digital Visual Interface (DVI) or Video Graphics Array (VGA) outputs in a single connector. A Y-style breakout cable is needed for the transition from the DMS-59 output (digital + analogue) to DVI (digital) or VGA (analogue), and different types ...
The signal standard and pinout are backward-compatible with CGA, allowing EGA monitors to be used on CGA cards and vice versa. Early VGA cards also used this connector. VGA connector (DE-15) Became a nearly ubiquitous analog computer display connector after first being introduced with IBM x86 machines. Older VGA connectors were DE-9 (9-pin).
The Video Graphics Array (VGA) connector is a standard connector used for computer video output. Originating with the 1987 IBM PS/2 and its VGA graphics system, the 15-pin connector went on to become ubiquitous on PCs, [1] as well as many monitors, projectors and HD television sets.
The later VGA standard built on this by mapping each of the 64 colors in from a larger, customizable, palette of 256. Standard EGA monitors do not support use of the extended color palette in 200-line modes, because the monitor cannot distinguish between being connected to a CGA card or being connected to an EGA card outputting a 200-line mode.
Prior to the DDC, the VGA standard had reserved four pins in the analog VGA connector, known as ID0, ID1, ID2 and ID3 (pins 11, 12, 4 and 15) for identification of monitor type. These ID pins, attached to resistors to pull one or more of them to ground (GND), allowed for the definition of the monitor type, with all open (n/c, not connected ...
The data is transmitted via the cable connecting the display and the graphics card; VGA, DVI, DisplayPort and HDMI are supported. [citation needed] The EDID is often stored in the monitor in the firmware chip called serial EEPROM (electrically erasable programmable read-only memory) and is accessible via the I²C-bus at address 0x50. The EDID ...
A monitor is typically connected to its host computer via DisplayPort, HDMI, USB-C, DVI, or VGA. Monitors sometimes use other proprietary connectors and signals to connect to a computer, which is less common. Originally computer monitors were used for data processing while television sets were used for video.
Mini-VGA connectors are proprietary and non-standard alternative video connectors that were used on some laptops and other computer systems in place of a standard VGA connector. Apple , [ 1 ] HP , [ 2 ] and Asus [ 3 ] each introduced separate connectors using the same moniker of "mini-VGA", but which are otherwise physically incompatible with ...