When.com Web Search

  1. Ads

    related to: professional grade rock polishing grit

Search results

  1. Results From The WOW.Com Content Network
  2. Tumble finishing - Wikipedia

    en.wikipedia.org/wiki/Tumble_finishing

    Tumbling of rocks as a lapidary technique for rock polishing usually requires a plastic or rubber-lined barrel loaded with a consignment of rocks, all of similar or the same hardness, some abrasive grit, and a liquid lubricant. Silicon carbide grit is commonly used, and water is a universal lubricant. The barrel is then placed upon slowly ...

  3. Rotten stone - Wikipedia

    en.wikipedia.org/wiki/Rotten_stone

    Rotten stone, sometimes spelled as rottenstone, also known as tripoli, is fine powdered porous rock used as a polishing abrasive for metal smithing, historically for the grinding of optical lenses and in woodworking. It is usually weathered limestone mixed with diatomaceous, amorphous, or crystalline silica.

  4. Lapidary - Wikipedia

    en.wikipedia.org/wiki/Lapidary

    The initial shaping and facet placement may be done using laps with grits of 220, 600, 1200. The polishing step, however, requires grits of a much higher grade, such as 8,000, 14,000, 50,000 and even 100,000. This grit is also embedded into a metal lap, but sometimes applied manually to the lap during polishing.

  5. Surface finishing - Wikipedia

    en.wikipedia.org/wiki/Surface_finishing

    Polishing lines will be soft and less reflective than a #4 architectural finish. #7 Finish. A #7 finish is produced by polishing with a 280–320 grit belt or wheel and sisal buffing with a cut and color compound. This is a semi-bright finish that will still have some polishing lines but they will be very dull.

  6. Polishing (metalworking) - Wikipedia

    en.wikipedia.org/wiki/Polishing_(metalworking)

    The condition of the material at hand determines what type of abrasive will be applied. The first stage, if the material is unfinished, starts with a rough abrasive (perhaps 60 or 80 grit) and each subsequent stage uses a finer abrasive, such as 120, 180, 220/240, 320, 400 and higher grit abrasives, until the desired finish is achieved.

  7. Sharpening stone - Wikipedia

    en.wikipedia.org/wiki/Sharpening_stone

    The term is based on the word "whet", which means to sharpen a blade, [3] [4] not on the word "wet". The verb nowadays to describe the process of using a sharpening stone for a knife is simply to sharpen, but the older term to whet is still sometimes used, though so rare in this sense that it is no longer mentioned in, for example, the Oxford Living Dictionaries.