Search results
Results From The WOW.Com Content Network
It covers buildings up to two full storeys high, plus a third storey in the roof space, on good ground. In a three-storey building, the floor area of the highest storey cannot exceed half the floor area of the lowest storey. The maximum building height allowed is 10 metres (33 ft), measured from ground level to the apex of the roof. [6]
Structural engineers generally consider a skyscraper as slender if the height:width ratio exceeds 10:1 or 12:1. Slim towers require the adoption of specific measures to counter the high strengths of wind in the vertical cantilever , like including additional structures to endow greater rigidity to the building or diverse types of tuned mass ...
Comparison of floor area ratio (FAR) or floor space index (FSI) and building coverage ratio (BCR) Floor area ratio (FAR) is the ratio of a building's total floor area (gross floor area) to the size of the piece of land upon which it is built. It is often used as one of the regulations in city planning along with the building-to-land ratio. [1]
A storey pole (or story pole, storey rod, [1] story stick, [2] jury stick, [3] scantling, [4] scantillon [5]) is a length of narrow board usually cut to the height of one storey. [6] It is used as a layout tool for any kind of repeated work in carpentry including stair-building , framing , timber framing , siding , brickwork , and setting tiles.
Deflection (f) in engineering. In structural engineering, deflection is the degree to which a part of a long structural element (such as beam) is deformed laterally (in the direction transverse to its longitudinal axis) under a load.
In engineering, a factor of safety (FoS) or safety factor (SF) expresses how much stronger a system is than it needs to be for an intended load.Safety factors are often calculated using detailed analysis because comprehensive testing is impractical on many projects, such as bridges and buildings, but the structure's ability to carry a load must be determined to a reasonable accuracy.
Use Newton's law of gravitation to calculate the radial altitude of both the ground and the roof. The difference will be the height of the building. Tying a piece of string to the barometer, which is as long as the height of the building, and swinging it like a pendulum, and from the swing period, calculate the pendulum length.
Partial height wall, a low wall that doesn't extend all the way up to the ceiling. Thin solid lines are used for built-in structures (such as cabinets, bookshelves, or plumbing fixtures). Thin dotted lines indicate overhead features, such as wall cabinets in a kitchen or a special ceiling treatment or an archway in the living room. North arrow ...