Search results
Results From The WOW.Com Content Network
An ICOM IC-7300 Radio Tuned to the 20 Meter Band. The ICOM IC-7300 is a multimode 6 meter, 4 meter (ITU Region 1 only) and HF base station amateur radio transceiver. [1] The IC-7300 was announced to the public at the Japan Ham Fair in 2015. [2] The radio has 100 watts output on CW, SSB, and FM modulations and 25 watts of output in AM. [3]
WSPR (pronounced "whisper") is an acronym for Weak Signal Propagation Reporter. It is a protocol, implemented in a computer program, used for weak-signal radio communication between amateur radio operators. The protocol was designed, and a program written initially, by Joe Taylor, K1JT.
A radio transceiver cannot cancel out its own transmit signal based solely on knowledge of what information is being sent and how the transmit signal is constructed. The signal that the receiver sees is not entirely predictable. The signal that appears at the receiver is subject to varying delays.
The jam signal or jamming signal is a signal that carries a 32-bit binary pattern sent by a data station to inform the other transmitting stations of the collision and that they must not transmit. [9] [10] The maximum jam-time is calculated as follows: The maximum allowed diameter of an Ethernet installation is limited to 232 bits. This makes a ...
Aurorae only occasionally affect signals on the 2 metre band. Signals are often distorted and on the lower frequencies give a curious "watery sound" to normally propagated HF signals. Peak signals usually come from the north, even if the signal originates from a station to the east or west of the receiver.
It allows several users to share the same frequency channel by dividing the signal into different time slots. [1] The users transmit in rapid succession, one after the other, each using its own time slot. This allows multiple stations to share the same transmission medium (e.g. radio frequency channel) while using only a part of its channel ...
An amateur radio propagation beacon is a radio beacon, whose purpose is the investigation of the propagation of radio signals. Most radio propagation beacons use amateur radio frequencies. They can be found on LF, MF, HF, VHF, UHF, and microwave frequencies. Microwave beacons are also used as signal sources to test and calibrate antennas and ...
This signal is a simple "high/low" status bit that is sent from a data communications equipment (DCE) to a data terminal equipment (DTE), i.e., from the modem or other peripheral to a computer in a typical scenario. It is present on virtually all PC serial ports - pin 1 of a nine-pin serial port, or pin eight over a 25-pin (DB25) port. Its ...