Search results
Results From The WOW.Com Content Network
Splices are therefore most often used when structural elements are required in longer lengths than the available material. The most common form of the splice joint is the half lap splice, which is common in building construction, where it is used to join shorter lengths of timber into longer beams.
This is the most common form of end lap and is used most in framing. For a half lap in which the members are parallel, the joint may be known as a half lap splice. This is a splice joint and is an alternative to scarfing when joining shorter members end to end. Both members in an end lap have one shoulder and one cheek each. Use for:
Mechanical couplers can be advantageous in comparison with conventional methods of lap splicing because of the requirement for less steel for overlapping. It is more effective in the seismic detailing to avoid reinforcement congestion problems. [3] The couplers are also used in pre-cast construction. [4]
Splice joint: A joint used to attach two members end to end. Scarf joint: A form of lap joint for attaching the ends of two members using bevel cuts. Knapp joint Also known as scallop and dowel, scallop and peg, [12] pin and cove, pin and scallop, or half moon.
A scarf joint may also be used to fix problems caused when a board is cut too short for the application. The board can be cut in half with a tapered cut yielding a scarf joint. When the joint is glued together, the tapers are slid against each other so that the two sections are no longer in line with each other.
Donald Trump and his billionaire ally Elon Musk have begun initiating the mass layoff of federal employees as the new administration strives to shrink the government’s workforce, with Musk ...
Only 2% of Chipotle's total sales come from Mexico, "which includes avocados, tomatoes, limes, and peppers." The company used to import 90% of its avocados from Mexico, but now it imports half ...
The simple halved joint is created by cutting a slot in opposite edges of the members to be joined so that they slip together. Most commonly, the amount of material removed is equal to half the width of the members being joined, although this depends on the relative dimensions of the members.