Search results
Results From The WOW.Com Content Network
Kinematic diagram of Cartesian (coordinate) robot A plotter is a type of Cartesian coordinate robot.. A Cartesian coordinate robot (also called linear robot) is an industrial robot whose three principal axes of control are linear (i.e. they move in a straight line rather than rotate) and are at right angles to each other. [1]
The radius and the azimuth are together called the polar coordinates, as they correspond to a two-dimensional polar coordinate system in the plane through the point, parallel to the reference plane. The third coordinate may be called the height or altitude (if the reference plane is considered horizontal), longitudinal position , [ 1 ] or axial ...
The drag curve or drag polar is the relationship between the drag on an aircraft and other variables, such as lift, the coefficient of lift, angle-of-attack or speed. It may be described by an equation or displayed as a graph (sometimes called a "polar plot"). [1] Drag may be expressed as actual drag or the coefficient of drag.
A polar diagram, or polar plot, is a graph that shows a sailboat's potential speed over a range of wind speeds and relative wind angles. [1] It normally consists of the right side of a line chart with the radius representing the yacht speed and the angle representing the wind direction blowing from top to bottom.
A polar diagram could refer to: Polar area diagram, a type of pie chart; Radiation pattern, in antenna theory; A diagram based on polar coordinates; Spherical coordinate system, the three-dimensional form of a polar response curve; In sailing, a Polar diagram is a graph that shows a sailing boats potential wind speed over a range of wind and ...
Forward vs. inverse kinematics. In computer animation and robotics, inverse kinematics is the mathematical process of calculating the variable joint parameters needed to place the end of a kinematic chain, such as a robot manipulator or animation character's skeleton, in a given position and orientation relative to the start of the chain.
In this configuration, the controlled endpoint or end-effector is the point D, where the objective is to control its x and y coordinates in the plane in which the linkage resides. The angles theta 1 and theta 2 can be calculated as a function of the x,y coordinates of point D using trigonometric functions .
Live Geometry is a free CodePlex project that lets you create interactive ruler and compass constructions and experiment with them. It is written in Silverlight 4 and C# 4.0 (Visual Studio 2010). The core engine is a flexible and extensible framework that allows easy addition of new figure types and features.