Search results
Results From The WOW.Com Content Network
The J-2 engine also had a slightly thinner head gasket, raising compression to 10.0:1. It was advertised with gross power and torque ratings of 312 hp (233 kW) at 4600 rpm and 415 lb⋅ft (563 N⋅m) at 2800 rpm. Oldsmobile charged $83 for the J-2 option with the three-speed manual (or in the 98), [7] $314 with the automatic. [8]
1948 Oldsmobile Straight-8 engine Oldsmobile inline 8 engine at the R. E. Olds Transportation Museum. Oldsmobile produced a straight-8 engine in the 1930s and 1940s. This was the company's top engine choice from 1932 until the 1949 introduction of the overhead valve Rocket V8, and was briefly exclusive to the Oldsmobile L-Series.
The standard J2 engine in Britain was the 3.6 L flathead V8 engine from the Ford Pilot, delivering 85 hp. [7] [8] A 4.4 L Mercury V8, delivering 110 hp was also available. [9] American enthusiasts modified their cars by fitting an Oldsmobile, Chrysler, or Cadillac V8. [4] [10] J2s exported to the United States were shipped without engines. [11]
Oldsmobile produced a straight-6 automobile engine from 1923 to 1950. It was a conventional side-valve engine of varying capacities and at stages was shared with GMC . Although the engines changed from year to year there were basically 5 series of Oldsmobile side-valve 6 cylinder engines over the 27 years of production, 1923 to 1927, 1928 to ...
M-Type Drophead Coupé 1948. The Allard Motor Company was founded in 1945, setting up in Clapham High Street, London. [4] Using its inventory of easy-to-service Ford mechanicals built up during World War II and bodywork of Allard's own design, three post-war models were introduced with a newly designed steel chassis and lightweight body shells: the J, a competition sports car; the K, a ...
Pages in category "Oldsmobile engines" The following 8 pages are in this category, out of 8 total. This list may not reflect recent changes. 0–9. Oldsmobile 307;
The GMC straight-6 engine was a series of gasoline-powered straight-six engines introduced in the 1939 model year by the GMC Trucks division of General Motors.Prior to the introduction of this new engine design GMC trucks had been powered by straight-six engines designed by the Buick, Pontiac and Oldsmobile divisions of GM.
The engine had a remarkably low idle speed of 450 rpm with standard transmission and 375 rpm (while in drive) for the automatic; [5] a modern engine is usually tuned to a minimum 600-700 rpm. The electrical system was a 6-volt primary with a negative ground, and a conventional mechanical ignition , with the firing order 1-6-2-5-8-3-7-4.