Search results
Results From The WOW.Com Content Network
The common installation method for laminate flooring is a floating installation, which means the floor connects to each other to form interlocked flooring system and is not attached to the sub-floor which means it is free to "float" over a variety of sub-floors. This includes existing flooring like ceramic tile and hardwood floors.
The usual mix is 1:3 and a colouring agent may be added to the mix to obtain a more attractive finish. The mix should be as dry as possible and the sand should be coarsely graded and clean to avoid shrinkage and cracking which might occur with a wet mix. The floor finish is carefully cured after laying.
This page was last edited on 6 August 2012, at 21:48 (UTC).; Text is available under the Creative Commons Attribution-ShareAlike 4.0 License; additional terms may ...
The foundation is one of the first things set when building a house. Concrete is poured and reinforced with steel rods. The structure serves as the ground floor of the house and supports ...
This is an especially popular method for solid parquet flooring installations on concrete sub-floors. Additionally, engineered wood flooring may use the glue-down method as well. A layer of mastic is placed onto the sub-floor using a trowel similar to those used in laying ceramic tile.
Ribbed slabs have higher load ratings than corrugated or flat slabs, but are inferior to waffle slabs. [15] A waffle slab gives added strength in both directions using a matrix of recessed segments beneath the slab. [16] This is the same principle used in the ground-bearing version, the waffle slab foundation. Waffle slabs are usually deeper ...
Nowadays, subfloors are generally made from at least two layers of moisture-resistant ("AC" grade, one side finished and sanded flat) plywood or composite sheeting, jointly also termed Underlayments on floor joists of 2x8, 2x10, or 2x12's (dimensional lumber) spaced generally on 16-inch (40.6 cm) centers, in the United States and Canada. Some ...
Wall framing in house construction includes the vertical and horizontal members of exterior walls and interior partitions, both of bearing walls and non-bearing walls. . These stick members, referred to as studs, wall plates and lintels (sometimes called headers), serve as a nailing base for all covering material and support the upper floor platforms, which provide the lateral strength along a