Ad
related to: mortise gauge vs marking chart for doors and windows 10
Search results
Results From The WOW.Com Content Network
Like the simpler marking gauge, a mortise gauge has a locking thumb screw slide for adjusting the distance of the scribe from the edge of the wood. It has two protruding pins, often called "spurs", [3] which are designed to scribe parallel lines marking both sides of a mortise at the same time. [4]
The gauge consists of a beam, a headstock, and a scribing or marking implement, typically a pin, knife, pen or wheel. The headstock slides along the beam, and is locked in place by various means: a locking screw, cam lever, or a wedge. The marking implement is fixed to one end of the beam.
A wood scribe is a tool for marking wood by scratching the surface visibly. A wood scribe is often used with a try square for accurate scribing. A marking gauge is a more specific form of wood scribe used to accurately mark wood for cutting, often for laying out mortise and tenon joints.
This category is for measuring and marking instruments used in woodworking, cabinet making, joinery, and carpentry. Subcategories This category has only the following subcategory.
Frames can be constructed by several methods: cope and stick, mortise and tenon, bridle joint, or a simple butt joint. Cope and stick is the most common method, as it is more efficient to manufacture. Mortise and tenon is the strongest, and is often used for large doors which will have greater stresses imposed.
A mortise is a hole cut into a timber to receive a tenon. There are several kinds of mortise: [16] Open mortise: a mortise that has only three sides. (See bridle joint). Stub mortise: a shallow mortise, the depth of which depends on the size of the timber; also a mortise that does not go through the workpiece (as opposed to a "through mortise").
Mitre square, for marking and referencing 45° angles, such as in woodworking for mitre joints. Spirit level, to check if a surface is level or similarly if a surface or edge is plumb (vertical). Depth gauge or height gauge. Form of marking gauge for marking lines parallel to an edge, by setting the head to a certain distance from the end of ...
Marking gauge; Mortise gauge; Depth gauge; Mitre level; Spirit level and plumb; Beam compass; Inside square; Ruler (a separate part used to enable many of the above functions. Often a four fold rule, trimmed in brass, was used) The name Odd Jobs denotes that the tool does many kinds of sundry tool roles.