Ads
related to: floppy disk drive interface for mac pro 16 with monthly payments today
Search results
Results From The WOW.Com Content Network
3.5-inch and 5.25-inch drives connect to the floppy controller using a 34-conductor flat ribbon cable for signal and control. Most controllers support two floppy drives, although the Shugart standard supports up to four drives attached to a single controller. A cable could have 5.25-inch style connectors, 3.5-inch style connectors, or a ...
Internal SuperDrive floppy drive on a Macintosh LC II. The term was first used by Apple Computer in 1988 to refer to their 1.44 MB 3.5 inch floppy drive.This replaced the older 800 KB floppy drive that had been standard in the Macintosh up to then, but remained compatible [citation needed] in that it could continue to read and write both 800 KB (double-sided) and 400 KB (single-sided) floppy ...
A proprietary riser card interface (referred to by Apple as an X-PCI slot) is located on the bottom of a Pippin system and is used by docking stations. A docking station for a Pippin can contain a variety of hardware, such as SCSI or floppy disk drive controllers, video interfaces, codecs, or network interfaces such as Ethernet.
It supported all of Apple's 3.5" floppy disk formats as well as all standard PC formats (e.g. MS-DOS, Windows), allowing the Macintosh to read and write all industry-standard floppy disk formats. The external drive was offered only briefly with support for the Apple II, coming late in that product's life.
Circuit components of the external USB SuperDisk for Macintosh. The drive itself is the same size as a standard 3.5″ floppy drive, but uses an ATA interface. On the right is the USB-to-ATA adapter, which plugs into an intermediate fan-out and power supply daughterboard that is inside the rear of the Mac drive's casing.
1 Floppy disk drives. 2 Hard disk drives. 3 Optical drives. 4 Other drives. Toggle the table of contents. ... Apple MacBook Air SuperDrive; Other drives. Apple Tape ...
In a later revision, this number was bumped up to 16 sectors per track with 6-and-2 encoding. [1] The floppy drive controller board, the "Disk II interface," [2] was built with 8 chips, one of which is the PROM, containing tables for the encoder and decoder, the state machine, and some code.
When the controller and disk drive are assembled as one device, as it is the case with some external floppy disk drives, e.g., Commodore 1540 and USB floppy disk drives, [27] the internal floppy disk drive and its interface are unchanged, while the assembled device presents a different interface such as IEEE-488, parallel port or USB.