Search results
Results From The WOW.Com Content Network
In telecommunications, insertion loss is the loss of signal power resulting from the insertion of a device in a transmission line or optical fiber and is usually expressed in decibels (dB). If the power transmitted to the load before insertion is P T and the power received by the load after insertion is P R, then the insertion loss in decibels ...
The insertion loss is not such a problem for an unequal split of power: for instance -40 dB at port 3 has an insertion loss less than 0.2 dB at port 2. Isolation can be improved at the expense of insertion loss at both output ports by replacing the output resistors with T pads. The isolation improvement is greater than the insertion loss added ...
The extra loss may be due to intrinsic loss in the DUT and/or mismatch. In case of extra loss the insertion loss is defined to be positive. The negative of insertion loss expressed in decibels is defined as insertion gain and is equal to the scalar logarithmic gain (see: definition above).
A match is good if the return loss is high. A high return loss is desirable and results in a lower insertion loss. From a certain perspective 'Return Loss' is a misnomer. The usual function of a transmission line is to convey power from a source to a load with minimal loss. If a transmission line is correctly matched to a load, the reflected ...
Coupling loss is usually expressed in the same units—such as watts or decibels—as in the originating circuit element or medium. [1] Coupling loss in fiber optics refers to the power loss that occurs when coupling light from one optical device or medium to another. (See also Optical return loss.) Coupling losses can result from a number of ...
Transmission loss in underwater acoustics describes the decrease of sound intensity that is reduced by a bubble curtain or other damping structure at a given frequency. The same term is sometimes used to mean propagation loss , which is a measure of the reduction in sound intensity between the sound source and a receiver, defined as the ...
In real systems, relatively little loss is due to mismatch loss and is often on the order of 1dB [dubious – discuss]. According to Walter Maxwell [2] mismatch does not result in any loss ("wasted" signal), except through the transmission line. This is because the signal reflected from the load is transmitted back to the source, where it is re ...
Transmission loss (duct acoustics) definition illustration with transmission matrix. The low-frequency approximation implies that each subsystem is an acoustic two-port (or four-pole system) with two (and only two) unknown parameters, the complex amplitudes of two interfering waves travelling in opposite directions.