Search results
Results From The WOW.Com Content Network
Making a fillet weld with gas metal arc welding. Fillet welding refers to the process of joining two pieces of metal together when they are perpendicular or at an angle. . These welds are commonly referred to as tee joints, which are two pieces of metal perpendicular to each other, or lap joints, which are two pieces of metal that overlap and are welded at the
The heat from the welding process and subsequent re-cooling causes this change from the weld interface to the termination of the sensitizing temperature in the base metal. The extent and magnitude of property change depends primarily on the base material, the weld filler metal, and the amount and concentration of heat input by the welding process.
Fillet geometry, when on an interior corner is a line of concave function, whereas a fillet on an exterior corner is a line of convex function (in these cases, fillets are typically referred to as rounds). Fillets commonly appear on welded, soldered, or brazed joints.
Welding joint. In metalworking, a welding joint is a point or edge where two or more pieces of metal or plastic are joined together. They are formed by welding two or more workpieces according to a particular geometry. There are five types of joints referred to by the American Welding Society: butt, corner, edge, lap, and tee. These types may ...
Methods of weld testing and analysis are used to assure the quality and correctness of the weld after it is completed. This term generally refers to testing and analysis focused on the quality and strength of the weld but may refer to technological actions to check for the presence, position, and extent of welds.
He is author of a newly revised McGraw-Hill textbook, Applied Strength and Applied Stress Analysis, 2nd Edition. Ali M. Sadegh is a professor and the Founder and Director of the Center for Advanced Engineering Design at The City College of New York. He is a Licensed Professional Engineer, P.E., and a Certified Manufacturing Engineer, CMfgE.
The Canadian Welding Bureau, through CSA Standards W47.1, [3] W47.2 [4] and W186, [5] specifies both a WPS and a Welding Procedure Data Sheet (WPDS) to provide direction to the welding supervisor, welders and welding operators. The WPS provides general information on the welding process and material grouping being welded, while the WPDS ...
The term material strength is used when referring to mechanical stress parameters. These are physical quantities with dimension homogeneous to pressure and force per unit surface. The traditional measure unit for strength are therefore MPa in the International System of Units, and the psi between the United States customary units. Strength ...