When.com Web Search

  1. Ads

    related to: can intake hurt engine fluid damage repair near me

Search results

  1. Results From The WOW.Com Content Network
  2. Starting fluid - Wikipedia

    en.wikipedia.org/wiki/Starting_fluid

    Starting fluid is sprayed into the engine intake near the air filter, or into the carburetor bore or a spark plug hole of an engine to get added fuel to the combustion cylinder quickly. Using starting fluid to get the engine running faster avoids wear to starters and fatigue to one's arm with pull start engines, especially on rarely used machines.

  3. Engine knocking - Wikipedia

    en.wikipedia.org/wiki/Engine_knocking

    If detonation is allowed to persist under extreme conditions or over many engine cycles, engine parts can be damaged or destroyed. The simplest deleterious effects are typically particle wear caused by moderate knocking, which may further ensue through the engine's oil system and cause wear on other parts before being trapped by the oil filter.

  4. Compressor stall - Wikipedia

    en.wikipedia.org/wiki/Compressor_stall

    Axi-symmetric stall, more commonly known as compressor surge; or pressure surge, is a complete breakdown in compression resulting in a reversal of flow and the violent expulsion of previously compressed air out through the engine intake, due to the compressor's inability to continue working against the already-compressed air behind it.

  5. Flooded engine - Wikipedia

    en.wikipedia.org/wiki/Flooded_engine

    Damage (due to excessive compression and even dilution of the lubricating oil with fuel) can also occur. This condition is known as the engine "flooding out." Possible causes of too much liquid fuel in the engine include a defective carburetor float that is not closing the fuel inlet needle valve, or debris caught in the needle valve preventing ...

  6. Hydrolock - Wikipedia

    en.wikipedia.org/wiki/Hydrolock

    In most steam engine designs there is a short time at the end of the return stroke of the piston when all the valves are shut and it is compressing any remaining steam. Water can be introduced from the boiler or in a cold engine, steam will condense to water on the cool walls of the cylinders and can potentially hydrolock an engine.

  7. Otto cycle - Wikipedia

    en.wikipedia.org/wiki/Otto_cycle

    The first person to build a working four-stroke engine, a stationary engine using a coal gas-air mixture for fuel (a gas engine), was German engineer Nicolaus Otto. [4] This is why the four-stroke principle today is commonly known as the Otto cycle and four-stroke engines using spark plugs often are called Otto engines.

  8. 6 tips to reduce alcohol use and cancer risk after surgeon ...

    www.aol.com/6-tips-reduce-alcohol-cancer...

    U.S. Surgeon General Dr. Vivek Murthy warned in a recent advisory about alcohol use increasing cancer risk. The advisory notes that alcohol can increase the risk of throat, liver, esophageal ...

  9. Crankcase ventilation system - Wikipedia

    en.wikipedia.org/wiki/Crankcase_ventilation_system

    The greater flow rate of intake air during these conditions means that a greater quantity of blow-by gases can be added to the intake system without compromising the operation of the engine. The opening of the PCV valve during these conditions also compensates for the intake system being less effective at drawing crankcase gases into the intake ...