When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Retaining ring - Wikipedia

   en.wikipedia.org/wiki/Retaining_ring

   A retaining ring is a fastener that holds components or assemblies onto a shaft or in a housing/bore when installed - typically in a groove - for one time use only. Once installed, the exposed portion acts as a shoulder which retains the specific component or assembly. Circlips are a type of retaining ring.

3. Circlip - Wikipedia

   en.wikipedia.org/wiki/Circlip

   A circlip (a portmanteau of "circle" and "clip"), also known as a C-clip, snap ring, or ', [1] is a type of fastener or retaining ring that consists of a semi-flexible metal ring with open ends that can be snapped into place into a machined groove on a dowel pin or other part to permit rotation but to prevent axial movement.

4. ANSI/ASME Y14.1 - Wikipedia

   en.wikipedia.org/wiki/ANSI/ASME_Y14.1

   A size chart illustrating the ANSI sizes. In 1992, the American National Standards Institute adopted ANSI/ASME Y14.1 Decimal Inch Drawing Sheet Size and Format, [1] which defined a regular series of paper sizes based upon the de facto standard 8 + 1 ⁄ 2 in × 11 in "letter" size to which it assigned the designation "ANSI A". This series also ...

5. List of thread standards - Wikipedia

   en.wikipedia.org/wiki/List_of_thread_standards

   ANSI/ASME B1.11-1958 (R2016) Microscope Objective Thread: V Thread Form ASME B1.13M-2005 (R2015) Metric Screw Threads: M Profile: V Thread Form ASME B1.15-1995 (R2003) Unified Inch Screw Threads (UNJ Thread Form) V Thread Form ASME B1.20.1-2013: Pipe Threads, General Purpose (Inch) Pipe Thread Form ANSI B1.20.3-1976 (R2013) Dryseal Pipe Threads ...

6. List of EIA standards - Wikipedia

   en.wikipedia.org/wiki/List_of_EIA_standards

   The EIA ceased operations on February 11, 2011, but the former sectors continue to serve the constituencies of EIA. EIA designated ECA to continue to develop standards for interconnect, passive and electro-mechanical (IP&E) electronic components under the ANSI-designation of EIA standards.

7. Preferred metric sizes - Wikipedia

   en.wikipedia.org/wiki/Preferred_metric_sizes

   In the United States, the alcohol industry switched to metric bottle sizes on October 1, 1976, abandoning the existing 38 sizes of bottles and instead adopting the following 6 sizes: [2] 50 mL (miniature) 200 mL (replaced the half-pint) (≈237 mL is a U.S. half-pint) 500 mL (replaced the pint) (≈473 mL is a U.S. pint)