Search results
Results From The WOW.Com Content Network
Hot extrusion is a hot working process, which means it is done above the material's recrystallization temperature to keep the material from work hardening and to make it easier to push the material through the die. Most hot extrusions are done on horizontal hydraulic presses that range from 230 to 11,000 metric tons (250 to 12,130 short tons ...
During an extrusion process it is essential to consider the surface finish of exposed product surfaces. As a general rule, the narrower an exposed surface, the more uniform its finish becomes. Webs, flanges and abrupt changes in metal thickness may show up as marks on the opposite surface of an extrusion, particularly on thin sections.
For example, for Aluminium, Magnesium and Copper alloys the minimum radius required for corners and edges is 0.75 mm whereas for ferrous metals for corners 1.5 mm and for edges 3 mm minimum radius is required. Good And Bad Practices while designing the cross section in Extrusion Process
The feasibility of a hydroforming process must take into consideration the initial tube material properties and its potential for variation, along with the bending process, hydraulic pressure throughout the forming process, in inclusion of axial feed or not, in order to predict metal formability.
Plastics extrusion is a high-volume manufacturing process in which raw plastic is melted and formed into a continuous profile. Extrusion produces items such as pipe/tubing, weatherstripping , fencing, deck railings , window frames , plastic films and sheeting, thermoplastic coatings, and wire insulation.
Friction extrusion is a thermo-mechanical process that can be used to form fully consolidated wire, rods, tubes, or other non-circular metal shapes directly from a variety of precursor charges including metal powder, flake, machining waste (chips or swarf) or solid billet.
Microextrusion is an outgrowth of microforming, a science that was in its infancy in the early 1990s. In 2002, Engel et al. expressed that up to that point, only a few research experiments involving micro-deep drawing and extruding processes had been attempted, citing limitations in shearing on billets and difficulties in tool manufacturing and handling. [1]
The Hall–Héroult process is the major industrial process for smelting aluminium. It involves dissolving aluminium oxide (alumina) (obtained most often from bauxite , aluminium 's chief ore, through the Bayer process ) in molten cryolite and electrolyzing the molten salt bath, typically in a purpose-built cell.