Search results
Results From The WOW.Com Content Network
In the most basic form, a quarter-wavelength section of coaxial cable is prepared such that the inner and outer conductors are separate but still attached to the remaining cable. The outer (shield) conductor is connected to a quarter-wavelength conducting sleeve into which the cable is inserted, and the inner conductor protrudes vertically ...
The commercially available B&W AC3-30 and B&W DS1.8-30 antennas [6] vary from the above to cover 3–30 MHz using a 90 foot length with an 18 inch spacing of the wires. The balun is a 16:1 ratio, thereby transforming the 50 Ω (ohm) coax to an 800 Ω feed at the antenna. The resistor load is also 800 Ω, non-inductive.
A transmatch (antenna tuner) is not required to use this antenna near its nominal design frequency of 14 MHz, and judicious length adjustments can sometimes include one other frequency band. All other frequencies require a transmatch. [citation needed] There are many variants of the G5RV antenna. Two variations of the G5RV design, called ZS6BKW ...
The G5RV antenna is a dipole antenna fed indirectly, through a carefully chosen length of 300 Ω or 450 Ω twin lead, which acts as an impedance matching network to connect (through a balun) to a standard 50 Ω coaxial transmission line. The sloper antenna is a slanted vertical dipole antenna attached to the top of a single tower. The element ...
Main page; Contents; Current events; Random article; About Wikipedia; Contact us; Donate
Inverted-'V' antenna When the two arms of a dipole are individually straight, but bent towards each other in a 'V' shape, at an angle noticeably less than 180°, the dipole is called a 'V' antenna, and when the dipole arms' end closer to the ground than their center branch-point, the antenna is called an inverted-'V' . The inverted-'V' is ...
How High Should a Dipole Be? A Look at Antenna Modeling - Intro to EZnec; Decoding Antenna Modeling Charts; Modeling Common Dipole Variations; Modeling the Simple Inverted Vee Antenna; Antenna Modeling a Modified Dipole with EZNEC 6+ 20/40 Two Band Dipole Modeled; What I discovered by modeling the MFJ-1846 Hex Beam
Yagi antenna with one driven element (A) called a folded dipole, and 5 parasitic elements: one reflector (B) and 4 directors (C). The feed line leading to the receiver is not shown; it attaches to the driven element at D. The antenna radiates radio waves in a beam toward the right.