Ads
related to: vented natural gas wall furnace cover plate installation
Search results
Results From The WOW.Com Content Network
The first key component within the outer housing is the firebox, which is surrounded on five sides by the outer housing, and on one side by the glass panel that faces towards the room. This is the space in which the fire burns during operation. Because of this, the gas burners (either natural gas or propane) are located inside of the firebox ...
Upright non-flued liquefied petroleum gas heater, 1970s A wall mounted gas heater that runs on either propane or natural gas. A gas heater is a space heater used to heat a room or outdoor area by burning natural gas, liquefied petroleum gas, propane, or butane. Indoor household gas heaters can be broadly categorized in one of two ways: flued or ...
Water-wall a furnace or other wall within a boiler enclosure that is composed of numerous closely set water-tubes. These tubes may be either bare, or covered by a mineral cement. Washout plug A small mudhole used for washing out the boiler. Plugs, as compared to mudholes, are usually screwed into a taper thread, rather than held by clamps ...
Ventilation should be considered for its relationship to "venting" for appliances and combustion equipment such as water heaters, furnaces, boilers, and wood stoves. Most importantly, building ventilation design must be careful to avoid the backdraft of combustion products from "naturally vented" appliances into the occupied space.
Electric heating or resistance heating converts electricity directly to heat. Electric heat is often more expensive than heat produced by combustion appliances like natural gas, propane, and oil. Electric resistance heat can be provided by baseboard heaters, space heaters, radiant heaters, furnaces, wall heaters, or thermal storage systems.
Diagram of natural draft gas furnace, early 20th century. The first category of furnaces is natural draft, atmospheric burner furnaces. These furnaces consisted of cast-iron or riveted-steel heat exchangers built within an outer shell of brick, masonry, or steel. The heat exchangers were vented through brick or masonry chimneys.