Ads
related to: gm 12 bolt car rear end oil fill ratio conversion
Search results
Results From The WOW.Com Content Network
Additionally, for Wrangler owners with high-horsepower GM LS engines, the 14-bolt can handle the engines' increased stress. [8] Many Wrangler owners will have up to two inches removed from the bottom of the 10.5" 14-bolt differential housing to maximize ground clearance. [9] The popularity of GM trucks and vans made 10.5" 14-bolt axles a common ...
Dana 61 axle tag showing 3.73:1 ratio [1] The Dana 61 was made in semi-float and full-float axles for select 4×2 and 4x4 Ford 3 ⁄ 4-ton and 1 Ton Pickups and Vans from 1974 to 1987. A Dana 61 front axle was selectively used in Dodge 4×4 3 ⁄ 4-ton and 1 Ton pickups from 1987 to 1993. Although 3.07:1 and 3.31:1 gear sets are common for a ...
Chevrolet 153 Inline 4 (Chevy II, pre-Iron-Duke - includes the Vortec 3000/181 industrial/marine crate motor) Detroit Diesel V8 6.2L and 6.5L; Duramax V8; Generation III V8s with modifications. These modifications include an additional bolt hole at the top of the pattern, and attachment points for cast oil pans to lower bellhousing extensions ...
2005–present 6L80 · 6L90 — 6-speed heavy-duty (used in GM trucks and performance cars) 2014–present 8L 90 — 8-speed heavy-duty (used in GM trucks and performance cars) 2016–present 8L 45 — 8-speed light-duty (used in GM luxury cars) 2017–present 10L80 — Ford-GM 10-speed automatic (used in GM light trucks pickups and related SUVs)
The AAM 9.25 solid axle was developed for 3rd generation Dodge Rams (3/4 and 1 Ton). The axle uses a modified Saginaw 9.5 differential, ring and pinion. The differential housing covers are identical except for one bolt hole at the 3 o’clock position. Model year 2010 and later Rams use larger universal joints than the 2003-2009 models. [1]
The Dana/Spicer Model 70 is an automotive axle manufactured by Dana Holding Corporation and has been used in OEM heavy duty applications by Chevrolet, Dodge, and Ford. It can be identified by its straight axle tubes, 10 bolt asymmetrical cover, and a "70" cast in to the housing, which is visually similar to the Dana 60. The majority of the Dana ...
Corporate 10-bolt axles were upgraded to 30 spline axle shafts from previous 28 spline shafts in 1989. In addition, the standard L05 5.7-liter V-8 now had one serpentine accessory drive belt in place of the older multi-belt accessory drive setup. 1989 was the first year for the NP241 transfer case and also the only year for speedometer cable ...
The Iron Duke I4 used by AMC in Jeeps from 1980 to 1983 used the standard small block Chevrolet bolt pattern bell housing. The later (1984-02) AMC I4 had the GM 60 degree V6/I4 bolt pattern, and this was retained for the life of the engine. AMC often used lighter duty transmissions with the four cylinder engines.