Search results
Results From The WOW.Com Content Network
Carbon build-up in the intake manifold will occur when blow-by gases are allowed to permanently contaminate the intake air because of a failing PCV system. [12] Carbon build-up or oil sludge from blow-by gases on intake valves are usually not a problem in port injected engines. This is due to the fact that the fuel hits the intake valves on the ...
Positive end-expiratory pressure (PEEP) is the pressure in the lungs (alveolar pressure) above atmospheric pressure (the pressure outside of the body) that exists at the end of expiration. [1] The two types of PEEP are extrinsic PEEP (PEEP applied by a ventilator) and intrinsic PEEP (PEEP caused by an incomplete exhalation).
A crossflow T-head sidevalve engine The usual L-head arrangement Pop-up pistons may be used to increase compression ratio Flathead with Ricardo's turbulent head. A flathead engine, also known as a sidevalve engine [1] [2] or valve-in-block engine, is an internal combustion engine with its poppet valves contained within the engine block, instead of in the cylinder head, as in an overhead valve ...
A serious issue with large single-sleeve aero-engines is that their maximum reliable rotational speed is limited to about 3,000 RPM, but the M Hewland car engine was raced above 10,000 rpm without toil. Improved fuel octane, above about 87 RON, have assisted poppet-valve engines’ power output more than to the single-sleeve engines’.
A camless or free-valve piston engine is an engine that has poppet valves operated by means of electromagnetic, hydraulic, or pneumatic [1] actuators instead of conventional cams. Actuators can be used to both open and close valves, or to open valves closed by springs or other means.
An idle air control actuator or idle air control valve (IAC actuator/valve) is a device commonly used in fuel-injected vehicles to control the engine's idling rotational speed . [1] In carburetted vehicles a similar device known as an idle speed control actuator is used.
A blowoff valve is designed to release pressure in the intake system when the throttle is closed. A "recirculating" type blowoff valve releases the pressurised air back into the non-pressurized section of the intake (i.e. upstream of the turbocharger), while an "atmospheric venting" type blowoff valve dumps the air directly into the atmosphere.
Valve timing diagram for a 4-stroke engine. With traditional fixed valve timing, an engine will have a period of "valve overlap" at the end of the exhaust stroke, when both the intake and exhaust valves are open. The intake valve is opened before the exhaust gases have completely left the cylinder, and their considerable velocity assists in ...